Latest activity

What's new New posts Latest activity

tg3690 reacted to redneck joe's post in the thread Random with Like.

https://www.facebook.com/share/r/1BigkLTfSX/

Jul 3, 2025
tg3690 reacted to redneck joe's post in the thread Random with Like.

https://www.facebook.com/share/r/1Dq7WEBhGh/

Jul 3, 2025
N

Nordin replied to the thread Reeds?.

I use razor blades, pocket knifes or putty knifes when removing old gaskets at smaller parts. At lager parts/surfaces such as bottom of...

Jul 3, 2025
R
rsrguy3 posted the thread Rookie move... ;) 75-ish Orrion in Boat Restoration, Building, and Hull Repair.

I'm new on the forum. Lots of mundane stuff happening lately at work... small jobs with no end in sight, but..... The bride of...
Jul 3, 2025
Z
ZafSC replied to the thread Thermostat too dirty.

Can somebody help me out there please? Is it ok if I place the thermostat like this?
Jul 3, 2025
Scott06 replied to the thread Wont fire on plugs.

Have you disconnected the shift interrupt switch ? If it is tripped it will kill spark. Disco it and test

Jul 3, 2025
C

Captain Davie replied to the thread Need help with ID of what's left of an 18' alum boat..

Thanks for the idea! They do have the same deep freeboard look. And also the same slightly drooping sheer. The Fiberglassic library is...

Jul 3, 2025
C
Captain Davie replied to the thread Need help with ID of what's left of an 18' alum boat..

The spray rail has a full length gas weld of 2 plates hidden just beneath it. They look both flanged outward and it would be an easy...
Jul 3, 2025
zippy83 reacted to Chris1956's post in the thread Water in the Lower Unit with Like.

It is not necessary to clean out the old lube. Just drain it well. Brake cleaner could harm the seals.

Jul 3, 2025
harringtondav replied to the thread Continuing Problem with 2021 VP 250 hp 4.3 DI.

@muc. Reply to your last post. Fuel story: Unknown bad winter leftover fuel. Topped off w/10 gals before splashing. Immediate symptoms...

Jul 3, 2025
C

Chris1956 replied to the thread Water in the Lower Unit.

It is not necessary to clean out the old lube. Just drain it well. Brake cleaner could harm the seals.

Jul 3, 2025
W

Wakelinj replied to the thread 3L cobra idling too high.

I'll have to consult the service manual on that one. Never messed with timing on an engine.

Jul 3, 2025
W

Wakelinj reacted to airshot's post in the thread 3L cobra idling too high with Like.

Setting idle speed should be done in the water while underway for best results.

Jul 3, 2025
W

Wakelinj reacted to 1960 Starflite's post in the thread 3L cobra idling too high with Like.

You may want to check the timing advance also. Advanced timing will increase idle RPM

Jul 3, 2025
S
searay250 replied to the thread Mercruiser MPI 5.0L w/ Bravo 3 outdrive not going into gear... lower shift cable is very hard to shift.

Ok, so there was a fair amount wrong when I checked the cable routing today. I tried to take a photo of the routing, but it's hard to...
Jul 3, 2025

Show older items

Top