Latest activity

What's new New posts Latest activity

P

padraicbc reacted to Scott Danforth's post in the thread Prop shaft broken at Cotter pin hole with Like.

tack weld the nut in place. the shaft is shot anyway

Yesterday at 4:26 PM
P

padraicbc reacted to alldodge's post in the thread Prop shaft broken at Cotter pin hole with Like.

Self locking nut

Yesterday at 4:26 PM
P

padraicbc reacted to alldodge's post in the thread Prop shaft broken at Cotter pin hole with Like.

Your probably right, my 250HP Verado only uses a lock nut and concave washer to hold prop on, but I also have fine thread

Yesterday at 4:26 PM
alldodge reacted to sphelps's post in the thread daily music fix with Like.

Wow , these guys are young on Carson .

Yesterday at 4:08 PM
alldodge replied to the thread Help with OMC 120.

It ran great for 30 minutes than it started having problems and it keeps getting worst. Could be a sucked up something and clogged up...

Yesterday at 4:06 PM
B

boscoe99 replied to the thread Tilt / Trim Motor Torque Specs.

Does the use of the word pedant make one one?

Yesterday at 4:04 PM
sphelps replied to the thread daily music fix.

Wow , these guys are young on Carson .

Yesterday at 4:03 PM
alldodge replied to the thread fuel gauge sending unit test.

Not sure if Bobcat uses same as USA standard since Doosan which is South Korea The typical 2 wire sender is one goes to gauge sense...

Yesterday at 4:02 PM
M

M0bi0us0ne replied to the thread Help with OMC 120.

We cleaned it and rebuilt it with new gaskets, float, needle, and accelerator pump

Yesterday at 4:00 PM
alldodge replied to the thread Help with OMC 120.

Carb is most likely needs cleaning

Yesterday at 3:57 PM
alldodge replied to the thread Frogs, Lizards and Wasps.

Have wasp, mud dabbers, carpenter bees and Bats no frogs, have lizards Mud dabbers fill every hole 1/4 inch or smaller with mud. Be...

Yesterday at 3:53 PM
M

M0bi0us0ne posted the thread Help with OMC 120 in OMC I/O & Inboard Engines & Outdrives.

I just swapped my OMC 140 for a 120. I needed an engine ASAP and didn’t have the time or the money for a new engine, sterndrive, and...

Yesterday at 3:48 PM
BWR1953 reacted to rolmops's post in the thread How would you answer this question? with Like.

A three and five year old have a short attention span and they need a lot of distraction. They also need to be able to move around...

Yesterday at 3:44 PM
alldodge replied to the thread Prop shaft broken at Cotter pin hole.

Your probably right, my 250HP Verado only uses a lock nut and concave washer to hold prop on, but I also have fine thread

Yesterday at 3:36 PM
FLATHEAD replied to the thread Trailer bearing blowout. Need help with repair(s).

I’ve ridden motorcycles my whole adult life. Total of 49 years to date. Have made multiple coast to coast rides. In all that time I have...

Yesterday at 3:34 PM

Show older items

Top

View All

View All

View All

View All

View All

View All

View All

View All

Boat Bimini Tops

Boat Covers

View All

View All

View All

View All

View All

View All

View All

Latest activity

Follow Us