Latest activity

What's new New posts Latest activity

D

drewm3i replied to the thread Alpha 1 gen 2 bellows service.

I have done that once lol! I was able to replace it without removing the engine but it was a *****! I was like 21 or 22 at the time and...

Aug 27, 2025
D

drewm3i reacted to Bt Doctur's post in the thread Alpha 1 gen 2 bellows service with Like.

when you decide to replace the bellows CUT the oil line before removing the hinge pins and remove the hoses using a razor knife...

Aug 27, 2025
Scott Danforth replied to the thread Dielectric grease--everywhere?.

I would not have put dielectric grease between the crimp terminals and the wire. crimp them dry, then use epoxy lined heat shrink. I...

Aug 27, 2025
Scott Danforth replied to the thread Boat had been stored for 19 years.

you are light on your estimates to redo the floor. the floor is the last thing to rot. you will spend $3500 just to redo the hull, add...

Aug 27, 2025
wvmedic reacted to racerone's post in the thread 1995 Evinrude E90TLEO charging with Like.

Something is wrong if you are not seeing 13.5 volts at cruising speed. !!

Aug 27, 2025
tpenfield replied to the thread Boat had been stored for 19 years.

The trailer is worth what you paid, so you are even at this point. Engine: I would get some PB blaster (or similar) into the cylinders...

Aug 27, 2025
M

mckaras replied to the thread 2003 Four Winns Vista 268 No power to accessories, cabin accessories, etc. Gauges have power and engine..

I reset all the breakers inside the cabin and the ones near the battery switch. Something’s been draining the juice out of the...

Aug 27, 2025
C

Candy Gramformongo replied to the thread Boat had been stored for 19 years.

Sounds like a awesome project. If it was put up in 2006 with fuel in the tank, then the tank will have to be removed and cleaned out...

Aug 27, 2025
M
Mc Tool replied to the thread BF35 water pump.

Well after fitting the new bits , basically the whole pump assy, the bastard thing was no better . 1st pic is the impeller housing...
Aug 27, 2025
R

robertw007 reacted to MikeSchinlaub's post in the thread Carbon fiber keel guard with Like.

Correction, Keel Shield.

Aug 26, 2025
R

robertw007 reacted to MikeSchinlaub's post in the thread Carbon fiber keel guard with Like.

Now that the pictures are working again, here's what I took of the Hamby I did. First, I dry fitted it and marked the edge with a...

Aug 26, 2025
jimmbo replied to the thread 1964 Evinrude Starflite 70hp impeller change.

In addition to unhooking the Wires, you will also have to pass the Wire Harness-Cable into the Exhaust Housing in Order to drop the Gearcase
Aug 26, 2025
jimmbo replied to the thread Drilling vent holes in a prop.

I found this from a few Years Ago. The V6 OBs use the same Props as the I/Os
Aug 26, 2025
redneck joe replied to the thread 82 Starcraft MR 180 floor, slight refit and leaks.

Are you at home? And you're not thinking stupid enough.

Aug 26, 2025
Fun Times reacted to tr@v1s's post in the thread Mercruiser 3.0 won't "lock in" with Like.

Thank you. I'm gonna try to tackle it myself. Looks pretty simple and straight forward.

Aug 26, 2025

Show older items

Top