Latest activity

What's new New posts Latest activity
  • J
    Jeff J replied to the thread Tritoon restoration.
    I just remembered. I have in my possession a recent written quote from a Bennington dealer to replace a starboard 22’ pontoon. $7635.70...
  • C
    chenlanlan replied to the thread Boat opinions.
    Regarding the hull type, the dealer was right - the Hewescraft 160 is fine in calm waters, but there are occasional waves in Puget...
  • nola mike
    nola mike replied to the thread Shift cable bellows..
    well, no, but without the prop locked the shaft will slip and flop around a bit.
  • C
    chenlanlan reacted to Bob_VT's post in the thread For New Members Needing help buying a boat. A Buyer's Checklist. with Like Like.
    Re: For New Members Needing help buying a boat. A Buyer's Checklist. The master plan here is to make this a sticky post :) If any...
  • Lou C
    Lou C replied to the thread 2003 Glastron VP 5.0 GL Overheat issue.
    https://leadersrpmshop.com/marine-parts/volvo-penta/ I have bought OMC parts from this vendor on Amazon, that's about the only one I'd...
  • tg3690
    tg3690 replied to the thread Force 120hp Major Overheat.
    If that's the original powerhead, then you got a 1990 model motor. Parts diagram for 1990 model shows a rubber grommet AND a rubber...
  • W
    wengr reacted to nola mike's post in the thread Shift cable bellows. with Like Like.
    But are they mated correctly? They both need to be in the same gear when mated, which is why the prop needs to be locked.
  • W
    wengr replied to the thread Shift cable bellows..
    Ahh so my lower shift shaft can be in the forward position - but the lower unit internally is actually not in forward?
  • i_build
    i_build replied to the thread 2003 Glastron VP 5.0 GL Overheat issue.
    Odd thing is that visually it looks ok was expecting to see pieces of the impeller. There are some small nicks at the end of the...
    • Amazon Pump.jpg
    • VP Pump1.jpg
    • VP Pump2.jpg
  • M
    MikeSchinlaub replied to the thread 1995 Crownline 202BR Restore.
    I assume this is all about getting the transom in, so here is what I recommend. 1. Attach transom to hull with thickened resin. 1a...
  • B
    beta replied to the thread 1995 Crownline 202BR Restore.
    Question about mixing resin... I understand the glassing process to be soak the wood surface with resin until it stops absorbing it let...
  • L
    Les0803 replied to the thread Power Pilot problems.
  • L
    Les0803 replied to the thread Power Pilot problems.
    I’ve taken the controller apart to see if I could see any worn parts. The warm up leaver automatically goes down when shifted into gear...
  • nola mike
    nola mike replied to the thread Shift cable bellows..
    But are they mated correctly? They both need to be in the same gear when mated, which is why the prop needs to be locked.
  • ESGWheel
    ESGWheel replied to the thread 2003 Glastron VP 5.0 GL Overheat issue.
    Here are some of my go to places for VP OEM Doug Russel Marine link Leaders RPM link Cecil Marine link > Cecil also sells Barr Other...
Show older items
Top