Latest activity

What's new New posts Latest activity

J

Jeff J replied to the thread Malfunction indicator Light constant on.

None specifically. The standards should be the same but how many boat mechanics are taught from day one that someone could die if they...

Aug 30, 2025
alldodge replied to the thread Bizarre IAC reading.

Right now I don't think you have an issue to worry about. As for adding sensors, I wouldn't do it even if wires were available, more...

Aug 30, 2025
alldodge replied to the thread WOT RPM Low. MAG350 MPI B3.

You have an issue with the fuel pump or regulator, should be 40 to 43 psi FUEL PUMP Assy The Reg is item 10 Fuel pump test procedure
Aug 30, 2025
W

wengr reacted to Bondo's post in the thread Shift cable bellows. with Like.

Ayuh,....... Even if you didn't touch the lower shift shaft, it moved into neutral, or beyond, just by the nature of the...

Aug 30, 2025
W

wengr reacted to nola mike's post in the thread Shift cable bellows. with Like.

Still don't think you're getting it. You need to have tension on the prop and lower shift shaft AS YOU REASSEMBLE. Let's make it simple...

Aug 30, 2025
B

billhig replied to the thread cowl air inlet on mercury 9.9..

I've already planned to replace the plug wires but I doubt they are the issue. they are not touching and the cowl is non-conducting.

Aug 30, 2025
FLATHEAD replied to the thread 2025 NFL/CFB News and Nonsense.

College football today. PSU on this afternoon looking forward to some good games.

Aug 30, 2025
J
JackMa posted the thread Crescent 45 (Archimede Volvo Penta ) help required in Other Outboard Brands.

Hello everyone, I'm new to this forum and also to boating and outboards, so I hope being here will help me to get up to speed with the...
Aug 30, 2025
nola mike replied to the thread Bizarre IAC reading.

idk. yeah you'd think the idle would increase or there'd be rough running. then again you say it's fully open but screenshot is fully...

Aug 30, 2025
flashback reacted to Bondo's post in the thread Shift cable bellows. with Like.

Ayuh,....... Even if you didn't touch the lower shift shaft, it moved into neutral, or beyond, just by the nature of the...

Aug 30, 2025
Scott Danforth replied to the thread Finally, a Funnel Solution!.

I have a cheap clear tub/tote thingy with a lid and 2 layers of the blue shop towels on the bottom I keep grease guns and funnels in...

Aug 30, 2025
Scott Danforth reacted to kd4pbs's post in the thread Finally, a Funnel Solution! with Like.

And here I’ve been using a coffee can and paper towels for over 40 years. All along, I could’ve bought a 3-D printer for the sole...

Aug 30, 2025
Scott Danforth replied to the thread Trim Tab Brackets.

The force on the brackets is low, and at the angle, primarily the bolts are in shear. No need to drill extra holes.

Aug 30, 2025
Scott Danforth replied to the thread WOT RPM Low. MAG350 MPI B3.

34psi is low

Aug 30, 2025
Texasmark replied to the thread Thrust Washer Question - Yamaha Performance 3 Prop.

Well back to the box of thrust washers. You can tell when you get a good fit.....taper on washer fits the taper on the prop shaft...

Aug 30, 2025

Show older items

Top