60 hp powerhead tear down pics

[Disco44]

Check that top carb very carefully for fuel level and/or dirt in the fuel circuits

Yes thank you, going to go through all 3

 

[Disco44]

First off thanks for the help getting me this far with the rebuild,

I do have a concern after buttoning everything up to torque specs, when I removed powerhead I could spin the Crank shaft with hand but now it does have some resistance if I try and turn it by hand after getting it back together. Is this normal with new pistons and rings?

 

[racerone]

Explain----" some resistance "-------You did line up bearings and dowel pins ?

 

[Disco44]

Explain----" some resistance "-------You did line up bearings and dowel pins ?

Yes dowel pins are lined up, it will turn, just not as easy before the tear down. I can hear it sucking air through plug holes, no strange noises. I guess I'm assuming it will be tighter with new pistons and rings, lol

 

[jimmbo]

Are there any spots where the 'resistance' increases then decreases? No spark plugs installed

 

[Disco44]

Are there any spots where the 'resistance' increases then decreases? No spark plugs installed[/QUOTE

No, seems smooth once turning,
Plugs haven't been installed as still on top of tool box, wiring and remount hopefully tomorrow.