O ring help

[kulle]

Does anyone know where these 3 orange o rings go? they came with transom repair kit. i have the one for the water passage installed, but not sure where these go. they seem too big or too small for the yoke. thanks

 

[kulle]

[No message]

 

[kulle]

forgot to post the pic

 

[Bt Doctur]

the 2 smaller ones go on the inputshaft under the gimbal bearing , the larger one goes on the input shaft if it has a groove for the o ring

 

[kulle]

the 2 smaller ones go on the inputshaft under the gimbal bearing , the larger one goes on the input shaft if it has a groove for the o ring

the larger one on "input" shaft, you mean the first groove on the yoke ?

 

[Bt Doctur]

Yes, first groove if your shaft has it ,

 

[kulle]

Yes, first groove if your shaft has it ,

yup, perfect got it thanks! well i got my outdrive back on! i did need to use the size 12 merc -kicker tool, but i completed my first ever -water shutter, ujoint , exhaust bellows and trim postion/sender install! need to fill with drive oil and pray she starts and the fwd/reverse work!

 

[JASinIL2006]

Small O rings go where the red circle is; large one goes in the location shown by the square.

 

[Bt Doctur]

well i got my outdrive back on! i did need to use the size 12 merc -kicker tool,
Did the drive come off easily?
Was the gimbal bearing replaced?
Did you check engine /coupler alignment?
If you answer No , something is still wrong because the drive should just push all the way on if everything is correct

 

[kulle]

well i got my outdrive back on! i did need to use the size 12 merc -kicker tool,
Did the drive come off easily?
Was the gimbal bearing replaced?
Did you check engine /coupler alignment?
If you answer No , something is still wrong because the drive should just push all the way on if everything is correct

2nd time is the charm..had to take it back off! damn drive shaft, turned and wasnt seated in the shoe on bell housing! learning curve!

 

[kulle]

well i got my outdrive back on! i did need to use the size 12 merc -kicker tool,
Did the drive come off easily?
Was the gimbal bearing replaced?
Did you check engine /coupler alignment?
If you answer No , something is still wrong because the drive should just push all the way on if everything is correct

yeah i replaced bearing and used the alignment bar. it went on good, just needed a little nudge, like 1/8 inch. im gonna muff test it this week.