waterinthefuel
Commander
- Joined
- Nov 15, 2003
- Messages
- 2,729
I haven't been on here in ages. We acquired an old Rhyan Craft aluminum boat. My father wants to install a new depth finder, but with the transducer shooting through the aluminum floor. It is a single floor boat, but I've only installed them shooting through fiberglass boat hulls. The instruction manual says nothing about installing them in an aluminum boat.
Any suggestions about if this can be done, and if so, the best way to go about it? I would assume if it is doable just epoxy it to the bottom of the boat like I did with fiberglass installations.
Any ideas would be helpful.
Any suggestions about if this can be done, and if so, the best way to go about it? I would assume if it is doable just epoxy it to the bottom of the boat like I did with fiberglass installations.
Any ideas would be helpful.