O Ring Replacement on Drive Shaft Question Mercruiser A1G1.

1985 Century Mustang

Chief Petty Officer
Joined
Mar 9, 2023
Messages
628
I have a question concerning the O rings that go on the Drive Shaft l, I'm doing my upper and lower seals on the outdrive .The seal kit came with Five O rings, 4 Black and One Orange. The Orange O ring is thicker than the other 4 and looks like it will fit fine. Do I use that one towards the yoke? Or should I just use the black one. Thanks
 
Last edited:

Fun Times

Moderator
Staff member
Joined
May 16, 2009
Messages
9,221
The bigger O-ring towards the coupler...Should look like the image below,
148M0204650--------O-RING (.924 x .103)29845SS
magnify.gif
$2.90$2.832
148M0204654--------O-RING (1.046)35027SS
magnify.gif
$1.70$1.66

1753735145977.png
 

1985 Century Mustang

Chief Petty Officer
Joined
Mar 9, 2023
Messages
628
The bigger O-ring towards the coupler...Should look like the image below,
148M0204650--------O-RING (.924 x .103)29845SS
magnify.gif
$2.90$2.832
148M0204654--------O-RING (1.046)35027SS
magnify.gif
$1.70$1.66

View attachment 410486
Is that a Gen2 Outdrive? I only have 2 slots on my outdrive for O rings that are towards the yoke. Photo enclosed..
Screenshot_20250728_165207_Gallery.jpg
 

1985 Century Mustang

Chief Petty Officer
Joined
Mar 9, 2023
Messages
628
Also, the lower seal I got in the kit is hard plastic and rubber unlike the upper seal, is this normal? Photo below

Screenshot_20250728_180022_Amazon Shopping.jpg
 
Last edited:
Top