Current visitors

alldodge's latest activity

alldodge replied to the thread Ujoints clunking?.

yes

Thursday at 2:09 PM
alldodge replied to the thread Ujoints clunking?.

Clip spacing is very important Using sealed bearings is ok. Greasable ones don't seal as well as sealed ones, this allows them to be...

Thursday at 1:54 PM
alldodge replied to the thread Sea Doo GTI 130 Owners?.

I have a 07 Doo with 155hp and it will pull toys but doesn't do a great job like a boat. The lighter the people the easier it is...

Thursday at 1:42 PM
alldodge replied to the thread bravo one drive shaft..

Show pic of your torque wrench? and is this inch pounds and not foot pounds

Thursday at 1:36 PM
alldodge replied to the thread Bravo 3 Sterndrive Reinstall- shift linkage wont come out to open.

One hand Grab with pliers and other hand rotate the drive shaft a bit, should come right out. If it takes a lot of force, remove top cap...

Thursday at 1:35 PM
alldodge replied to the thread Ujoints clunking?.

Old on right correct? The issue will be not being able to grease it once installed

Thursday at 1:32 PM
alldodge replied to the thread Cool Fuel Gen 3 Module Sea Water Connection.

Use a hair dryer or heat gun on low setting. Heating it up should allow hose to be removed. Could also cut the hose to remove it and use...

Thursday at 10:30 AM
alldodge replied to the thread Short vhf antenna.

About every VHF antenna out there will fit it. Short, medium, tall all use same mount

Thursday at 9:27 AM
alldodge replied to the thread No spark thunderbolt 5..

That was the TBV troubleshooting guide, right? The spark is triggered from the module in the distributor with the Wht/Red and Wht/Grn...

Thursday at 9:25 AM
alldodge replied to the thread Boat will run perfect in neutral and will rev up in neutral but will die instantly.

Welcome Which 4.3, GL, GXI, serial numbers are best?

Thursday at 5:44 AM
alldodge reacted to 1985 Century Mustang's post in the thread I'm doing my Bellows. Mercruiser A1G1. Are the Amazon Bellows Kits any good? with Like.

The bellows kit came today, it's actually decent, the rubber is real nice, the gimbal bearing is real sweet too. I purchased mine on...

Thursday at 5:40 AM
alldodge replied to the thread Bravo 3 Driveshaft Oil Seal.

Vid by Achris on preload

Thursday at 5:40 AM
alldodge reacted to Bondo's post in the thread Mercrusier 260 closed cooling system, squealing sound water pump with Like.

Ayuh,....... Those pulleys are Nasty, 'n the belt is so worn out, it don't ride up on the pulley where it should,...... Generally...

Jun 18, 2025
alldodge replied to the thread helm wiring, should be simple, i'm not too bright..

Boat wiring is pretty simple compared to most other things
Jun 18, 2025
alldodge replied to the thread Bravo 3 Driveshaft Oil Seal.

Yes but not retainer nut the pinion gear nut Yes and No Yes torque to 200 ft lb No, the rolling resistance has nothing to do with the...
Jun 18, 2025