The idle speed on this engine is ultimately electronically controlled. There are 2 throttle valves on this engine, the main throttle body, and what is called an IAC valve. IAC stands for Idle Air Control. Click this link for a diagram -...
I had this exact motor. A "simple" cleaning of the carb isn't good enough. Take it off , (carefully), and do a thorough cleaning. Be careful though, cause back in 2014ish there were limited carbs available, so if you jack this one up, you might be SOOL Yes, if you are using a trash can the...
So this post caught my eye. I have a 25 hp efi, and I as well have been running into issues with WOT. Low RPM's to be exact, (seems to run fine at lower throttle settings) which obviously means no mph. Which really sucks with the 25. Anyway, my motor has a HP and LP fuel filter, The low...
If you didn't already do this, then here's how. Get a drill and small drill bit about 1/16 inch. carefully center the drill bit on the brass plug, (careful not to damage anything). Drill in half way. reverse drill, pull back. plug will come out. I did this on a 9.8 tohatsu. Came from...
I have a 2006 25hp EFI Mercury that seems to idle too high. The motor starts and runs fine. At the end of 2020, I was out on the lake when all of a sudden after I cranked it over the idle speed seemed to be too high. I'm guessing 1500 RPM's . It will shift into gear ok, and when in gear the...
Hi all, I have a 2006 mercury 25 EFI on a 2007 lowe stinger 160. The motor will not plane out and seems to barley do 8-10 mph. It runs very well at idle but at full throttle with load I can only get 4100 rpm, (full range 6k). The motor out of water gets up to the full range. The boat is...
Is their a way to adjust the interlock on a 9.8 nissan. The electric start will not engage in the neutral position unless you lightly pull the shift lever forward. (not switching into gear). The electric start should engage while the shift lever is in its normal position.
