Hello all, long story short, was told this was a 2002 Johnson . 50 hp bombider . The welsh plug is the only thing left for tag. I can add pictures if needed but here is a picture of the plug
Hello all, long story short, was told this was a 2002 Johnson . 50 hp bombider . The welsh plug is the only thing left for tag. I can add pictures if needed but here is a picture of the plug
Yes I have , I have a 25 hp a little newer but same concept . So I switched coils and wires . Didnohma reading on stator and trigger . Stator seems to be a little lower . So I orderd a new one . But spark at coil does not reed high . Can someone tell me what type of voltage I should be looking...
Yes I have . No change . I even thought of maybe someone out the coil wires on wrong . So took off fly wheel and everything looks good under it. Did some readings off the stator. According to CDI BLACK /white to Brown/yellow should be 650-850 ohms . Mine reads 742 so good .
Low speed should be...
So I have a spare tester . I set it to 1 inch spacing and tested spark. Was all over , put it to 3/4 it was a lot better . I put a straw in cyl 1 turned it till it was TDC . Then I looked at the flywheel it was on the two dots so the book shows that as setting the base time. As for the link...
I have a 20hp Mercury. I have set the timing on the motor. Cleaned the carb. I have 140psi both cyl.
I have great spark. Will jump 3/4 or 1 inch gap.
I did an ohms readings on coils compared to my 25 . They are in spec . I spray starting fluid in carb buttterfly open , then turn key it fires...
Yes I do push the key in for the choke ? But it is not clicking. So I need to check to make sure it is getting voltage . That is my first attack for that. As for the carb . I had a 25 johnson and the low speed idle was in the front top center. But the 30 carb says it is a plug . So just screw...
So I think it may be a 1987 by decals . But I could the number plate . So I can buy parts for carb etc…
It is an electric remote ? If you need more ask please
I just got a 30 hp johnson . The problem is the tag is missing from the frame.
I did find the welsh plug with the numbers stamped on it . But it does not seem to help me . I can’t find anything B171608
The carb throws me too has an adjustment for screw at top this only adjust when in gear I...
