I have replaced the power pack ($165) and still don't have any spark. I checked both spark plugs (using a screwdriver to check for spark) and nothing. Any ideas on where to go from here? I can't imagine that both coils would have gone out at the same time.
Thanks in advance.
I have a 1972 model Evinrude electric shift (model # 50173 S) that stays in gear (forward) even with no switch wired in. Is this common? The push buttons were sticking and I wanted to replace them with a toggle. Can I not do this? Does someone have a wiring diagram for the shifter?
Thanks...
I have a 1970 model 40hp Johnson with Electromatic shift that is giving me shifting problems. I had a post several weeks ago regarding this, but the problems have changed. I took the boat out last week and the transmission would not engage in order to back off of the trailer. When I wired...
I have a 1970 40hp Johnson electromatic shift motor that does not want to go when I put it in gear. I know the prop is spinning when in the driveway, but when I get it in the water all it does is churn the water behind the boat, but wont push it. I have checked the shear pin and it is fine...
I have a 1970 40hp Johnson that is not getting any fire. The motor tries to turn over but just wont kick. I just swapped it onto this boat from another and I think I might have mis wired the switch. Can anyone tell me what the following wires run? I have in-laws visiting and they want to go...
I have a 1970 model 40 hp Johnson motor I am thinking about putting on a 1971 model Glastron V156. The smallest motor I have seen on one of these boats is 60hp. I am not looking to go fast, I just want to get out on the water. If I do this, am I going to have problems?
Thanks in advance...
