Also, When I turn the idle air needles in or out it changes the way it idles so I figured it had to be the carbs. I'm trying to get the settings for the air and set it back to factory to see if it will idle.
I had the powerpack, coils, plugs and sensor replaced and the idling has gotten worse since. Do you think it is the bowls or the carbs need kits? Thanks for your input.
I have a 2000 Johnson 90hp that idles rough with the air screws 10 turns out. If I run them in to 5 or 6 turns it will not idle. How many turns out are these carbs suppose to be set at? What type of carb issues causes this? Thanks for your help!!
1991 Johnson 200hp. When I started it up today I had a tremendous amount of smoke and a unsmooth idle. When I increased the rpms it smoked even more. It was stuttering last weekend until I got above 1000rpms, then smoothed out. I checked the firing and it is steady on all cylinders. This is...
I have a 25' boat trailer with the light ran inside the trailer beams. The old wiring needs to be replaced with new. When I try to pull it out with new wire attached, it keeps getting hung up. Is there a way to run new wiring through the beams by pushing some type of heavy wire through first...
1991 Johnson 200hp J200TXEIB
I recently removed my lower unit to replace impellar and forgot to adjust shift rod height, so the reverse is not engaging properly. When I put the lower unit back on I tightened the shift rod bolt to tight and twisted the head off. I don't think it will be hard to...
J200TXEIB 1991 Johnson 200hp.
I removed the thermostats when I bought this boat about a year ago because I thought I had a overheating problem but it ended up being carbs, tuneup, and electrical issues. I got all that repaired.
I have been running it without thermostats since last fall and...
1991 Johnson 200hp, J200TXEIB. I recently replaced my Stator, Regulator/Rectifier, and Powerpack due to the rectifier shorting out and catching fire. After doing more research on my engine today, I cannot get to shut down without choking it. The engine is running good and firing on all...
Re: Engine wont shut down!!!!!
I appreciate that.
After doing more research on my engine today, I cannot get to shut down without choking it. The engine is running good and firing on all cylinders. It starts as soon as I turn the ignition switch.
The only question I have is the wiring coning...
My engine will not shut off when you turn the ignition off, and the Tach stopped working. it slows down an finally boggs out, but does not shut down immediately. Does this sound like the ground?? Advice appreciated.:confused:
I have a 1991 Johnson 200hp that starting misfiring. Now the ignition switch will not engage starter everytime. Sometimes it will spin the motor but appears to be firing weak. Then the next time you turn the key you get nothing. I checked the battery connections and they are ok. There is about 6...
