I bought a new water pump kit and replaced. Reinstalled lower unit. Started up and have strong discharge from pee hole! Old impeller looked good, but almost seemed stuck when removing it? Had to jump the battery to start boat, need new battery. I can hardly lift old battery, it is 27 series. I...
Update: Started this morning, no flow out pee hole. Removed thermostat and ran still no flow. I run on a lake, no salt. Impeller changed 2-3 years ago, but it appears to be the problem like you said. Right? Thanks
Hi Gang, I have a 1996 120hp Force outboard. I was getting it ready for season and am getting the high temp alarm while running water via the ear muffs. Had good flow out pee hole. A couple years ago I changed the thermostat and it as been cooling fine since until now. I filled a large tub with...
Hi Gang, As it turned out the voltage/reg/rec I bought new was bad. I got one from a different company and the battery is now being charged. Thanks to all for the help!!
I am seeing between 25vac at idle up to 60vac on rev up out of the stator (yellow wires). So the voltage/rectifier should be seeing that as it's input. Yet the battery vdc voltage does not go up even when revving up the motor. I did some ohm check comparisons on the bench between the old and new...
As far as I understand the system, the stator and voltage regulator/rectifier is supposed to charge the battery with a higher voltage. The vom shows the battery at 12.5vdc when not running and the same when the motor is running. Am I missing something?
Hi Gang, Hope someone has a tip for me. I have a pontoon with a 70hp Force outboard. It runs fine, but not charging the battery when running. I've replaced the stator and the voltage regulator/rectifier. Still not seeing a higher voltage going to the battery. It's just running on the battery...
The 'right spot' I assume is neutral? I had it in neutral after removing the lower unit the 2nd time, but after reinstalling and running the motor it wouldn't turn the prop when I shifted into fwd or rev?? Thanks again for your patience!
Sorry for being an idiot, but I don't understand what you are saying? I can turn the drive shaft by hand and it makes the prop turn whether I'm in neutral, fwd or rev. The shift shaft connector I turn with channel locks, but when I had it in neutral and reconnected to the motor and started the...
Thanks Jerry, As I understand what you are saying is that the actual shifter is not quite in neutral? On the other end in the lower unit with it taken off , does the spline connector when turned by hand have stops going CW and counter CCW? And I need to have it in neutral (free turning prop)...
Hi and Thanks for any help, Prior to changing the water pump I had the shifter in forward position. While reinstalling lower unit I had trouble getting it to mesh the last 2 inches. I put the shifter in neutral to see if that would help. It didn't. Turned flywheel while trying to install and it...
