I replaced the oil tank on my 50hp merc. Am i supposed to bleed the lines between the oil pump and tank. If so how do you do it? Any help would be awesome. I would like to go gator hunting tomorrow and not run into any preventive problems. i see one pin hole bubble thats it so far. All help is...
SO i tested the new motor i bought it will start first time but then die right after. Then i try to restart it it will not start unless i high idle it. Starts but well not idle. So i give it a little gas then put it in fwd. Runs fine at about 2500rmp then bogs downs at high rpm but will some...
my 78 evinrude lower unit is pretty much shot(model 35853r) . Will this 79 work? (model number 35953r)
I have no clue how to research it to find out thanks.
I just bought a 20ft jon boat with a custom built gas tank. Well it has no gas gauge or a spot to put one in at. I can not remove the tank as it is welded in place.
How can i add something to tell me how much is in there?
not spitting water checked the impeller looks good and you tell me where the water hose is to se if anything blocked? would i have to lower the lower unit again?
Well i took my boat and motor out for the first time since i bought it no leaks! But my motor seems to have problems. Running fine shuts of after about 15 mins. i have determined i need a new impeller i think that whats its called so it wont over heat.
this isnt my exact motor but i have 2...
No sure the yr its a 50/50 mix pull start. I try to pull start it and it will not start. What should i check for? i am new to this so plase help, I guess i would be stupid in these catorgory
