Recent content by kd4pbs

  1. kd4pbs

    Connect alternator outputs of two motors to battery bank

    Battery isolators supply a sense terminal for this exact reason.
  2. kd4pbs

    Connect alternator outputs of two motors to battery bank

    Ever jump started a car? Ever notice how that when you jump start it successfully and both engines are running, nothing blows up, smokes, or fails even if you leave the jumper cables connected for quite some time to more rapidly charge the vehicle with the dead battery? Nothing different here...
  3. kd4pbs

    Strange frequency and voltage on paguro vte 4000 diesel generator *with video*

    I'm not sure what your definition of a "sensitive" load is, but most every modern electronic device will have a switching power supply. As such, they are highly immune to variations of input voltage and frequency. These little miracles can take garbage in and create pure DC out. 265 volts is...
  4. kd4pbs

    I was just four months old

    The issue is that one still has to pay to watch it. Broadcast television requires a wire and a TV. That's all. No internet. No email address, contact info, and financial data sitting on someone's server ready to be hacked.
  5. kd4pbs

    New Stuff on Vehicles likes/dislikes

    Thankfully it is a small 2 lb. or so gel-cell battery like is found in emergency lighting. the weight of the battery and the servo are pretty much offset by not having a cable, bracketry, and all associated linkages. Aside from a few idiosyncrasies, both of these MB SUVs we own is just as easy...
  6. kd4pbs

    Mercruiser Setting Timing on 3.0L

    Glad you've got it figured out, Dan! The bride and I have been "up in the holler" enjoying a much-needed vacation totally disconnected from the world, and it felt great! We're looking forward to hearing about your adventures.
  7. kd4pbs

    New Stuff on Vehicles likes/dislikes

    At least Mercedes Benz thought about the potential issue of a dead battery and an electronically shifted (via a servo motor actually moving things that a cable could just as well do) by having a smaller battery that has only one purpose: moving that servo out of park in case the main battery is...
  8. kd4pbs

    I was just four months old

    I sure hope they decide to return to free broadcast television with this, just like all of the foundation the whole ST universe was built upon. Otherwise, that will be yet another series that scads of die hard fans won't see.
  9. kd4pbs

    Mercruiser Setting Timing on 3.0L

    There will be no issue with the differences. Looking at the old gasket, every spot between cylinders were bad. I think you'd be well right to have the head milled and verify correct timing upon reassembly. That's what we call down in these parts, "Blowed up big time!"
  10. kd4pbs

    Mercruiser Setting Timing on 3.0L

    Note the old gasket is a FelPro. I don't know that Mercruiser used those OEM, so that's likely a replacement. Might want to look up the part number just for kicks to see if that's a marine set - not that if it isn't this would be the cause for that blowout. For sure the other spot was on it's...
  11. kd4pbs

    Ford 302 engine oil dipstick - 1995 OMC Cobra, Ford 302, VolvoSX

    I figure the likes of Mercruiser and Volvo-Penta had the smart engineering figured out. On an automobile, that's all you got if it's not an air-fluid heat exchanger. It would be more effective than nothing if you put it in the block cooling loop, but since it's easy to plumb into the seawater...
  12. kd4pbs

    I was just four months old

    Sulu didn't do a very good job of parking 'er that morning.
  13. kd4pbs

    Mercruiser Setting Timing on 3.0L

    Now that I think about it... I wonder if it was just a copper colored spray paint that I experienced on that head gasket. I've never had to go back into anything I've used the copper coat on. It either worked fine (my '05 Jeep Liberty CRD is still in the stable) or I eventually sold the...
  14. kd4pbs

    Mercruiser Setting Timing on 3.0L

    Thanks for the warning - I'll have to remember that. I have seen on one head after years of assembly (2.4L L-6 Datsun engine) the same thing happens on a copper coated composite head gasket. It sure was a PITA to clean, but man, that thing sealed well! That's the first time I had ever seen...
Top