Hello
Interesting info had not seen before.
Click on the picture , then click again and should open big enough to see, you can then
right click the picture ands either save it to you computer or print it.
Happy hunting :-)
Hello
I am installing a fuel/water separator filter, some questions
1. does the squeeze bulb go before or after the filter
2. does the filter need to be mounted below the output from the tank.
3. do I need to "prime" the filter ( fill it with fuel )
thank you
Re: 92 johnson 140 hp vro pump
Hello
Before spending a ton of money do the following
Go to Oriely's or auto zone and borrow their radiator cap test kit, remove the cap adapter from the pump and hose and get a 1/4 to 3/8 adapter and some 3/8 hose to allow hookup to the puls hose adapter on...
Re: Testing VRO Pump.
Hello
Go to Oriely's or auto zone and borrow their radiator cap test kit, remove the cap adapter from the pump and hose and get a 1/4 to 3/8 adapter and some 3/8 hose to allow hookup to the puls hose adapter on the pump follow attached troubleshooting procedure.
Hello
I am decarbing motor according to Capt. Bob Dunkelburger decarb FAQ
I have done the Decarb acording to the instruction however am running out of time to run
the beast in my neighborhood, can i leave the mixture overnite or do i need to run CLEAN fuel
through it tonight?
1993 Evinrude...
Hello
on my old 70 hp stinger the squeeze bulb will pump up hard BUT
on my new ve175gletr 175 hp 1993 evinrude intruder the bulb will not get hard
new bulb and line, no leaks , VRO Disabled ( but still VRO fuel pump)
when i squeeze it i get this sound like a frog coming from the top left side...
Hello
1993 evinrude 175 glet
power coil reading for voltage and ohms to high
dva voltage connected 49 should be 11to 22
dva voltage disconnected 190 should be 45 to 120
resistance 90 ohms should be 50 to 60
This is the black sleeved stator and blue sleeved power pack
my understanding is...
Hello All
Does anyone have any tips for removing the plastic optical encoder wheel from the crank shaft
without destroying it, i have to replace my optical sensor, or should i just order a new one while i am at it.
1993 evenrude intruder 175 hp
thanks
miker
Hello
the tabs on the optical sensor are actually broken and it is just sitting there wiggle wiggle
Question :
was having a problem with the motor dying a 1/2 to WOT, just like you turned off the switch
at slow speed engine USSUALY ran ok but would turn off sometimes
Could this be the...
Hello
I have a 1993 evinrude intruder 175 hp model e175glet
has 110 compression in all cylynders but 1 which is 100
I have not / and probably never has been de-carbed
motor runs good / has CDI problem (ordered DVA to trouble shoot) may need new powerpack
is this enough compression to make...
Hello
I have a 1993 Evinrude Intruder 175 HP model e175glet
Can you install a temperature gauge on the motor
I think it may be running hot and causing the motor
to die
thanks
miker
Hello All
I have a Evinrude Intruder 175 hp # VE175GLETR (VRO REMOVED before I bought the boat) Just bought the boat. (1994 Bayliner Redevous 2609)
The engine has had this problem for awhile.
Boat starts and idles fine, runs slow fine, but when you run it 3/4 to WOT it will run out good the...
