My mistake wrong link. This is the gauge that is attatched to a mechanical fuel sending unit.
https://rochestersensors.com/wp-content/uploads/DS-923.pdf
According to the link, there’s supposed to be a positive 12 volts and ground which all checked out.
Yamaha Command Link Square Speed Gauge won’t register how many bars of fuel in tank. The boat has two seperate tanks with new mechanical/magnetic senders (click the link)
https://www.moellermarine.com/moeller-marine/fuel-accessories/swingarm-mechanical-sending-unit-12-tank-depth-035754-10/
For...
2011 LF225XCA left trim piston binds immediately engaging in trim after tilt. The trim piston and seals were changed due to a trim fluid leak. Last season after install, the trim moved smoothly then after a few weeks it started sticking to the point you’d have to toss your weight on the back of...
Apparently everything has been changed (upper/lower cables, interuptor switch, shifter at helm and the upper Alpha drive portion.) I’ve spent hours playing with adjustments according to Mercruiser’s spec and still no luck. Cables move freely while disconnected. Sometimes the boat stalls shifting...
Typical issue stalling while shifting into neutral. Sometimes the boat almost stalls and other times it does. I checked the cable measurements all seemed fine including cable play amount. While watching the shift interuptor switch and shifting, I noticed the switch isnt always moving as it...
I like the idea of gantry’s however they limit your ability by job depending if the boat can fit between it; atleast one like the HF I posted. A forklift is limited too when swim platforms exist. I’m all about investments which is why I’d like to hear about other ideas since there’s so many...
Hey all. Completed a project over the weekend removing a 454 and changed the engine coupler (pictures below). Normally a skid steer or forklift is used to hoist engines out, I’ve done a bunch, but my resources were limited and I had to get creative. I was wondering if anyone has ideas of a...
I already own a service manual and have briefly glanced at what would be involved however Im curious if anyone could steer me in the right direction to what else I should check on the drive side before complete drive disassembly.
