Hi All, sorry for multiple threads, I am working on a 1963 28HP Speeditwin. I just replaced the coils and points, but there are also stop switch/kill switch wires in the ignition plate. Do I wire these to the same post as the condensers/coils? Or to these go somewhere else? I keep seeing...
So at first I couldnt pull it at all, finally got it to where it would pull well enough that I could perform a compression test. I just replaced the coils but when i tighten down the nut on top the entire ignition plate moves and then stops and I cant move it any further. When i take the...
HI All,
I recently purchased a 1963 Evinrude 28 HP Speeditwin. It is hard to pull the start cord, but when I take the plugs out it pulls really easy. Others have mentioned this is probably a mechanical problem of some sort. Could it be a bad woodruff key? I have attached pictures. I am very new...
I have a 63 Evinrude 28 HP speeditwin that I am trying to restore. The throttle rod from the gear shift to the middle section is in good shape, the rod that connects the handle to the powerhead is missing. Right now I am trying to start but it is hard to tell what the start position should be by...
I will be honest, i am not sure--i know the lever on the side has fwd reverse and neutral, and I have been trying to pull in neutral. I can build up a better stand, it is on a sawhorse right now. This motor doesnt fit my boat so I cant secure it that way. I have a 55 gallon drum i could hang it...
Hi Everyone,
First off I am a complete rookie, I have repaired mowers and such but am new to outboards.
I just bought a used 1963 Evinrude 28HP 28302A longshaft. When I try to pull start I cannot pull the thing, but when I take the plugs out it spins fine and easy. There is about 4 inches of...
