LWD's latest activity

  • L
    LWD reacted to nola mike's post in the thread Gauges recommendation with Like Like.
    Are you sure the gauges are bad?
  • L
    LWD reacted to legalfee's post in the thread Gauges recommendation with Like Like.
    I went with Faria Chesapeake to match the Suzuki multi-function installed when I repowered. The MPH gauge isn't hooked up but I get...
  • L
    LWD reacted to ratdude747's post in the thread Gauges recommendation with Like Like.
    I mostly have Faria Beede gauges on mine. Very good quality and not stupid expensive. The original 1976 Starcraft gauges were very faded...
  • L
    LWD reacted to airshot's post in the thread Gauges recommendation with Like Like.
    Make sure all connections, splices or any other electrical joints are thoroughly clean and shiny before hooking up new gages. Good luck...
  • L
    LWD reacted to BWR1953's post in the thread Gauges recommendation with Like Like.
    Well, earlier this afternoon I pulled the trigger on the new gauges. They'll start coming in next week. Gives me time to do a bit of...
  • L
    LWD replied to the thread Gauges recommendation.
    I haven't removed my gauges yet, not sure I'll need to at this point. I may end up taking your lead on this. (y)
  • L
    LWD reacted to airshot's post in the thread Gauges recommendation with Like Like.
    In my years of boat ownership, most issues with gages have been corroded, dirty, loose connections !! Could count on one hand the...
  • L
    LWD replied to the thread Gauges recommendation.
    You've got quite a project there. Sounds like we're thinking along the same lines, and it's like reading something I would have written...
  • L
    LWD reacted to Chris1956's post in the thread Gauges recommendation with Like Like.
    SeaRay Gauges are normally made by a commercial gauge company. Sometimes they add the SR emblem to the gauge, but they are usually...
  • L
    LWD replied to the thread Gauges recommendation.
    I disconnected the battery, and the gauges stayed the same. I notice the fuel gauge is closer to accurate with the key off, but normally...
    • 01.jpg
    • 02.jpg
    • 03.jpg
  • L
    LWD replied to the thread Gauges recommendation.
    Thank you for all the replies. I'll disconnect the battery, good idea. dingbat, I haven't considered it an over voltage issue, although...
  • L
    LWD replied to the thread Gauges recommendation.
    I'd almost rather have bad gauges, but it would be a lot worse to go through the expense and work of replacing them, only to not make a...
  • L
    LWD replied to the thread Gauges recommendation.
    Honestly, now that you ask, I'm not sure. Could there be something else I'm not aware of?
  • L
    My tachometer has been going out for a few years, last year my voltmeter starting pegging at 16 volts all the time, till I turned off...
  • L
    if you still have a bit of the stud left, put on a push-on rubber cover from your local ace hardware with a bit of black silycone. I...
Top