I have a bad steering arm assembly and i heard rumor that there was a thread on replacing one. Anyone have it bookmarked? I couldn't find it through the search.
Hello,
I am having an issue with our port side engine. The engine is a Yamaha LF225TXRC. Sometimes when I switch from idle to neutral the engine cuts off. I have read and searched the net for a couple days and have found multiple sites with this topic. The part in question is called a variation...
Hello all,
I have an older BF20 2hp and just started having some issues with it. I have a plan of attack but was hoping that someone may have had some experience with these little engines.
When first starting the engine it starts fine and runs fine. Then about 2 minutes into use, it begins...
We have been having problems with our livewell and have a tournament coming up. The problem is that the pump will turn on, start pumping, and nothing reaches the baitwell. There is a raw water outlet right next to the baitwell that is getting water. So i know the pump is working. Oh and this...
Hello,
We have a big tournament coming up and are at our wits end trying to figure out a bait well pump issue. First let me start by saying up until two days ago the bait well did not work at all. I was able to isolate the pump and connect it directly to the battery, it ran. Then removed the...
I'm in the process of rebuilding a trailer that has a TON of surface rust. The rims and lugs are shot, so I need to remove them before sand blasting the trailer. I have a couple questions. If i remove this star nut that holds in the bearing, will this also release the hub from the axle for me...
Taken From the VRO to Premix Sticky Here:
http://forums.iboats.com/showthread.php?t=388154
"Now cut the oil line about 1 ? inchs from motor. Plug the oil line. I use a bolt and hose clamp."
After this step i can actually remove the entire oil line to include the oil reservoir can i not? I am...
Hello,
I have an 89 Crossflow 150 that i am having an issue with. On the trim tilt there are three pistons. The secondary two on either side and the primary center piston.
My first issue is my center piston. It seems to be leaking fluid out of the top ring/seal of the piston. Is this...
Violet is 12v hot wire from Ignition. Grey is tach.
Is black an already grounded wire ran from the engine block? Or does it NEED to be grounded.
Thanks.
I have replaced all the wires with new ones and have checked all the terminals. The gauge is still not reading very consitant.
Double check my wiring i provided please and see if i did everything right. I am going to load test the sending unit tomorrow. But i really think that it is the gauge...
I have a 1989 Evinrude 150. It has been slowly giving more and more problems on cold starts. It has gotten to the point where it takes a good squirt of Ether to get it going. Once started she runs like a champ.
Does this sound like a choke issue? Or is it the fact that i store the engine in...
Ok so i was running the engine on the muffs yesterday and i touched the port side of the block and it felt a little warm, not bad. Felt the starboard side and it about left a blister. I turned off the engine and opened up the thermostat housing. Thermostat was dry on the backside that opens up...
So i have already adjusted my trim tab on the foot and it helped a little. But it still pulls until i trim up. I am missing a large section of my skeg and it is soon to be fixed. Will this repair help any? WHat other variables cause pull? Sort of stumped. Thanks.
I have an 89 150 upper and want to install a temp gauge. Do they have a threaded plug somewhere intended for this purpose. Or would I be better off with a stud mount type on the block?
