Recent content by PAULWI

  1. P

    Set up for operating engine out of the water

    Wanted to show my set up for checking my 1987 110 without being in the water. Just need to watch temp of water in barrel.
  2. P

    1987 110 evinrude engine controls

    I am sending some pictures of the controls for shifting and speed. The Seloc manual is very lacking on description of the timing of engine. I have changed some parts in the ignition, overhauled the carbs and want to make sure everything is correct. Book calls for measuring 12 degrees before...
  3. P

    PDF overhaul manuals purchased online

    Have any of you purchased an online PDF copy of a overhaul manual? I have the Solco manual which isn't worth the paper it is printed on.
  4. P

    1987 110 evinrude correct wire hook up from power pack to coils.

    Yes this me with spark problems ok put things back together Seloc book calls for the orange and blue wire connected to #3 and #4 coils and solid orange wire connected to #1 and #2 coils is this correct. Reference being that #1 cylinder is top on starboard side. What makes me question is I...
  5. P

    1987 110 spark problem

    I have been having trouble with spark intermittent no start. 1. Assembled a peak voltage tester for stator output (output 197 both sides) 2. Tested output from timer base above.3 volts. Disconnected black yellow wire still has intermittent spark. Couple nights ago disconnected wires from output...
  6. P

    1988 evanrude 110 small tubes both sides of manifld

    What do the small tubes that are attached to the manifoild do for the engine? I was told they have to do with oil but reading they are called balance tubes. I am in process of putting front of engine back together after pulling bottom end off installed new seals, bearing, and water pump.
  7. P

    1988 evanrude 110 small tubes Called balance tubes

    What does the small tubes that run on both sides of the manifold do was told that they have to do with oiling? I want to understand what they are for I am in the process of putting the front back together after hooking up the shifter lever that runs from gearbox.
See more
Top