Current visitors

Home
Members

Scott06's latest activity

Scott06 replied to the thread No start after engine install. Need Help!!!.

If y What Is the serial number of the engine ? Yes normally there are two wires on negative side of coil one to ignition module one to...

May 23, 2025
Scott06 replied to the thread What prop? I'm lost.

Given you don’t have a prop I assume you just bought the boat? Personally Try a 19” 3 blade aluminum to rough in where your wot rpms...

May 23, 2025
Scott06 replied to the thread 93 mercruiser 4.3 alpha one gen 2 fuel problem (I think).

yes the fuel pump or off purple wire will provide a igntion on 12 v source

May 23, 2025
Scott06 replied to the thread Help me set up my new edelbrock 1409.

Bottom right of the first and top left of second of the page have how you should do it. This is out of the merc 3.0 manual.
May 22, 2025
Scott06 replied to the thread Can I lubricate the cutlass bearing with something so I quickly test forward and reverse on the trailer.

Water is what lubes it in use

May 22, 2025
Scott06 replied to the thread Help me set up my new edelbrock 1409.

It’s under load idle will drop from where it is in neutral

May 22, 2025
Scott06 replied to the thread No start after engine install. Need Help!!!.

Good point . I have. 2 grey wires on mine one to coil one to tach. If no wire is on net post of coil It will not fire. can disconnect...

May 22, 2025
Scott06 replied to the thread No start after engine install. Need Help!!!.

Go through the rest of the TB troubleshooting guide.

May 21, 2025
Scott06 replied to the thread No start after engine install. Need Help!!!.

The TB troubleshooting guide starts with verifying the tach wire isn’t shorted to ground …

May 21, 2025
Scott06 replied to the thread Hole shot.

So I….

May 21, 2025
Scott06 replied to the thread No start after engine install. Need Help!!!.

Disconnect the tach wire (grey) at negative post on the coil. This will remove any chance the tach is killing the spark you can also...

May 21, 2025
Scott06 replied to the thread Engine hour meter clicks with ignition on, but engine not running.

On an analog engine that is the only way to know it is running ( or should be…) power to ignition circuit.

May 20, 2025
Scott06 replied to the thread No start after engine install. Need Help!!!.

the oil pressure alarm doesn’t interrupt the ignition. It just makes the buzzer go off when below 4 or 7 psi.

May 20, 2025
Scott06 replied to the thread No start after engine install. Need Help!!!.

Wi willing to bet during cranking you are loosing voltage, start with positive battery and ground cables.ther are 2-3 at the back on...

May 20, 2025
Scott06 replied to the thread outdrive stuck.

That’s the point with a press you wont damage the splines unless you are chit faced…a bar on either side of the bearing or use bearing...

May 20, 2025

Show older items

Home
Members

Top