Recent content by siusaluki23

  1. S

    1979 mercury 7.5 pull start assembly

    Can someone go over the assembly procedure for the whole pull start. 7.5 horse, 1979. Rope broke and I took it apart to replace the rope and the pawls/washers fell out and I want to make sure i put it back together correctly. Thanks
  2. S

    1970 johnson 60 carb cleaning steps

    Will someone please go over every step in graphic detail for me. 1970 johnson 60 horse 3 cylinder electric shift. also what is the correct gear lube for this motor?
  3. S

    wrong flywheel?

    i just noticed that the flywheel on my 1970 johnson 60 inline 3 says that it 1969 V4. um...is this a problem? engine idles well but slowly loses power and then surges.
  4. S

    where is my tell tale

    1970 johnson 60 HP where is the tell tale i am told that most of the water comes out of the prop?
  5. S

    engine loses power after short run

    1970 johnson 60 electric shift it will run fine for a short while and then it will slowly lose power. , then it will surge like it is wanting get going.IF i idle for a little bit it will run well for a short while and then slow down again. carbs are clean and i beleive just rebuilt...
  6. S

    fuel pump for 1970 johnson 60 electric shift

    can't seem to figure out what fuel pump i need. anyone know of a model number or an aftermarket pump that will work?
  7. S

    engine won't crank over

    1970 johnson 60 hp. took it out for the first time today, engine cranked over for a second and then it stopped and won't turn over(makes no noise at all). i have power to the engine because i can here the choke when i hit the switch. I am guessing it is the starter or solenoid. help me out...
  8. S

    prop won't spin on new minn kota

    prop won't spin but i can turn the head from side to side! it's a 40 LB minnkota edge bow mount foot control. I'm using 1 battery, could it possibly be a 24 V so i would need two batteries? anyone have any ideas?
  9. S

    stupid question about steering

    hey guys, this is pretty stupid but, is there a special bolt i need to attach my steering linkage to my outboard. I replaced an old pulley system with rotary, and when i bought the boat nothing was attached (can't find original equipment). Is there a steering arm of some sort or do i bolt the...
  10. S

    i/o steering for outboard?

    can i use a steering system from a searay (15 ft cable) on my outboard. it would be mounted on a 16 foot fishing boat. i beleive that it is a rack and pinion but im not sure.
  11. S

    1970 evinrude 60 HP won't shift

    hey i have 1970 evinrude 60 horse electric shift that will not shift. engine runs and it looks to be in great condition. I was told by the former owner that it was an electrical problem in the lower unit? is this the shift solenoids or could this be in the control box?
See more
Top