Can somebody advise the year of manufacture of my outboard?<br /><br />Evinrude 140 HP<br />Serial: A342830<br />Model: 14093R<br /><br />Thanks<br />John
I have 2 fuel tanks and on occasion I run out of fuel at full speed. (140HP Evinrude 2 stroke premix). Is there a possibility of causing engine damage or is there enough residual oil in the motor to accommodate this situation.<br /><br />Thanks<br />John
When I raise and lower the tilt and trim there is and loud squeaky squawking noise. I think it is coming from the top cylinder rod pivot pin & bush. However I tried to knock the pivot pin out with no luck looks like it is stuck fast. Has anyone got any ideas on the cause of the noise and if it...
When I raise and lower the tilt and trim there is and loud squeaky squawking noise. I think it is coming from the top cylinder rod pivot pin & bush. However I tried to knock the pivot pin out with no luck looks like it is stuck fast. Has anyone got any ideas on the cause of the noise and if it...
I have fitted new gear selector cable, checked my Clymer manual guess what no info!!<br />What I did was adjusted it to the mid position between forward and reverse but it clunks into reverse. Is there a different method or is what I have done correct?<br />Thanks<br />John
I drained the oil from my 140hp Evinrude today and noticed that about 4 teaspoons of clear water ran out before the oil. The oil was not milky. Should I be concerned about this or is it normal to collect a small amount of water maybe condensation in the leg.<br /><br />Thanks<br />John
I owned a 115 Johnson on a 16' Ski boat and was advisd to drill a small hole at each blade through the hub of the propeller, this improved the ability to pull skiers out of the water.<br />I now own a 140 evinrude and would like to do the same however I do not remember the hole size and exactly...
