Recent content by stoksey25

  1. S

    Trailer suspension

    Hi I have an 70s Fletcher on what I only assume is the trailer it came on. My question is that the suspension is not the indisuspension but a 1 leaf spring across the trailer with 2 stub axles on each end . Can you get these type still and from where. I am in the UK Regards Neil
  2. S

    Mariner 60hp

    Hi again I have found that I need a exhaust gasket for my 1986 mariner 60hp. Serial 9444374 could any one point me to the right part number and best place in uk to purchase please Regards Neil
  3. S

    Cracked casing

    Hi all I need some advice. I have a yam 60hp 1994 . Getting it ready and general maintenance today and found a crack in the gearbox casing just in front of the prop and about 10 cm long . My question is can this be repaired. (Tiger welded) or is it scrap. It is not leaking but do not want it to...
  4. S

    Yamaha 60hp 1994

    Hi I need to change the trim motor on my outboard. I have undone the trim assembly but how do you actually get it off as it seems wider than the bracket itself
  5. S

    Crescent 3 9 outboard

    Hi all I have aquired a small air cooked crescent 3 9 outboard . It needs some TLC and I need to take leg off. Would anyone have any diagrams or manuals for these engines or point me in the right direction . Thanks in advance Neil
  6. S

    Towing u bolts

    Hi all I have a old fletcher. I want to start towing inflatables and perhaps have a go at wakeboarding. I need the harness and u bolts. What is the best setup for a 1970 boat . Many thanks Neil
  7. S

    1989 60hp trim

    Hi I have a problem with the motor on the trim. The relays click as they have always done but now the motor does not run at all. I have tested the wires coming from the relays and the voltage is there as you would expect. Is there any common problems with these motors I should look for before...
  8. S

    Mariner 60 charging

    Hi all I have a Mariner 60 hp that does not seem to be charging. Multimeter across battery shows 12v with and with out engine running. Could any one tell me how to check the charging system as I have the manual but am not sure if I am following right. many thanks in advance Neil
  9. S

    Model id

    Hi there, I know there are charts on here to Id engines but I still cant make out what the numbers denote The numbers are 60FETO 6H2 L 455228 Could any one shed light on what they mean Regards Neil
  10. S

    mariner 30hp 1981

    Hi could anyone tell me why there are three screws on the lower unit . 1 oil level 2 oil drain and 3 wash . What are they for Regards Neil
  11. S

    Mariner 30 hp

    I have gad a look this morning and where I need to get is below where my finger is pointing. I cant see how taking the Carb off will allow me to get in here any thoughts please
  12. S

    Mariner 30 hp

    Here is a picture
  13. S

    Mariner 30 hp

    Hi I have a Mariner 30 hp mid 80 serial 30m 689s 009915 I have taken gear housing off to find the small tube is in two parts so I need to order one of those but my question is about the gear selector. I thought I needed to disconnect this before removing the LU but as I did the top part...
  14. S

    Mariner 60hp 1986

    Hi all. I have got a question about my mariner 60hp. I have use the engine and boat for the first time since I bought it a few years ago. After a lower leg oil change a new impeller and case and new plugs it all started up ok and seemed to warm up ok and not get to hot. After I got away from...
  15. S

    Mariner 60 hp 1984

    Hi all I have put my new impeller in the new case and give it all a good clean . Put the muffs on and started the water supply. When I started the engine I expected the water to just come from the tell tale hole but it was coming from the hole and looked like the exhaust aswell as the two small...
See more
Top