Recent content by summers2short

  1. S

    Fuel tank leak

    Ok, update here, I managed to get that nut off and there is no o-ring or any type of gasket there. The aluminum sleeve just threads down into the moulded plastic of the tank. Should I put an o-ring under that nut, make a gasket, or use some permatex motoseal gasket maker?
  2. S

    Fuel tank leak

    Thanks guys, yes definitely no shop vac!! Yikes! Ok, then to replace sender rubber gasket, can I just make a new one out inner tube or do I need to find a part for that? The vent tube does have a loop to keep water out, but has been hard to fill this year, I will check it for blockage.
  3. S

    Fuel tank leak

    Thanks Scott, do I need to empty the tank before pulling the sender? It’s about half full right now.
  4. S

    Fuel tank leak

    Hi everyone, I noticed a fuel tank leak on the elbow that comes from the pump into the tank. See picture, it’s leaking between the large nut and the tank. I’m wondering if anyone knows if there is an o-ring under there or how it’s sealed? Wanted to ask before I try and undo it in case there...
  5. S

    speedometer pick up tube

    Ahhhh, I didn't realize exhaust bellows actually fill with water, thought maybe there was a one way flap or something. Thank you everyone for helping out a newbie!
  6. S

    speedometer pick up tube

    Ok, I'm new to the forum and learning a lot about my boat. I have a 1996 Maxum 1900sr with a 4.3L mercruiser and Alpha I Gen II outdrive. I have replaced all the bellows and trim sending units, I am about to put it back together and this is likely a ridiculous question but I need to know...
See more
Top