Recent content by zippy83

  1. zippy83

    Water in the Lower Unit

    That is what I’ll do.
  2. zippy83

    Water in the Lower Unit

    I repeated the steps above. Pressure to 10-12psi. Rotated the drive/prop/shift shafts. No leaks. Let is sit 30 min and pressure held at the same levels as started. I will fill her up with sea 90 and head out to lake of the woods. Will stay there 10 days and will probably put good 10 hours on it...
  3. zippy83

    Water in the Lower Unit

    I did rotate the drive shaft, but did nothing with the shift shaft and the prop shaft. I still have it all apart so I will check that once again.
  4. zippy83

    Water in the Lower Unit

  5. zippy83

    Water in the Lower Unit

    So I have performed a pressure test. Pumped it up to 13psi and left it for 15 minutes. Sprayed it occasionally atound the shift shaft/drive shaft/prop shaft with soapy water and nothing. Pressure held at 13psi Not sure what to think of it. I have also tried two different pumps just to make...
  6. zippy83

    Water in the Lower Unit

    what seals are likely to go after 4 years of use? 250 hours...
  7. zippy83

    Water in the Lower Unit

    it is a very small amount Im guessing. here is what it looked like after it was all drained
  8. zippy83

    Water in the Lower Unit

    Hi All, I have a 2021 Mercury proxs 200HP outboard, and during my last lower unit oil change I noticed slight amount of water in the lower unit. Since then I changed the drain and vent gaskets, filled it back up and put about 25 hours on it, and wanted to check the oil again and there was some...
  9. zippy83

    Bent skeg on outboard

    Thanks everyone. I was able to use the hammer and a block on the opposite side and carefully bring it back to as close to normal as possible.
  10. zippy83

    Bent skeg on outboard

    Can I use one of those disposable homeowners torch yellow bottle? If so, how long should I heat the skeg from each side before attempting to straighten.
  11. zippy83

    Bent skeg on outboard

    Hi all, I was drifting down the wind and hit a log with my outboard. Even though it was trimmed up it was hard to see and the result ended up being a bent skeg. Is there a way it can be bent back?
  12. zippy83

    Water in the powerhead

    On my outboard the drain plug is completely submerged under water. It has been checked and seems to be not leaking…
  13. zippy83

    Water in the powerhead

    Thanks for the reply. I guess I can keep my eye on it. I told them to check out thermostat and see if its showing good. It is 2 years old and might be the issue.
  14. zippy83

    Water in the powerhead

    Hi all, I have a 2021 mercury pro xs 200 and during my last oil change I noticed that there was some water in my oil. For the first 10-15oz the color of the oil was milky and then te rest of the oil looked normal (dark brown) I took it to the service and they told me that its NORMAL for some...
  15. zippy83

    Outboard life expectancy

    Thank you all. Looks like regular maintenance will go a long way.
See more
Top