Search results

  1. A

    1988 travler lake Erie

    I just bought a 1988 traveler 1900cc it is 18'8" long it has a 115hp Suzuki outboard my ? is is this a safe boat to run on lake Erie Or is it suited more for the inland lakes thanks
  2. A

    1988 traveler boat

    I just bought a 1988 traveler center console. Made in Tifton Georgia . I cant seem to find any info on it if anyone knows more please let me know
  3. A

    1988 suzuki dt140

    Hello everyone just bought a boat with a 1988 suzuki dt140 with low compression in one cylinder. my ? is is this a jo a fairly handy person can tackle and are they motor worth putting money in.
  4. A

    gauges

    I have a 1973 65hp triumph on a small center console that has no gauges I would like to add temp volts and tach if possible. I would like to know if this is possible whats involved and recommendations on the actual brand
  5. A

    1971 mercury 1150

    I have a 1971 mercury 1150 what I am wondering is is there a way to start motor without the harness hooked up to boat
  6. A

    fuel lines

    Hello everyone I have a 73 65 hp Evinrude runs well but the fuel lines on it look a little dried out. Is there s specific fuel line i need does it need to be USCG approved Is tygone a good choice Thanks for any replies
  7. A

    1973 65 hp

    Looking at a 1973 evinrude 65 hp motor comes with controls,has spark in all 3 cylinders and compression 1 135 2 135 3 120 It has sat for min 3 years compression taken without any oil in cylinder looking at approx worth thanks in advance for your replies
  8. A

    1976 85 hp evinrude

    Going to look at a 1976 85 HP evinrude anything I should look for . Thanks in advance
  9. A

    1971 Fleetwing

    Hello everyone Merry Christmas I just bought a 1971 fleetwing center console Boat was made in Cocoa Florida. I have done some searching and can not find out any info on this boat. So if anyone knows anything about them let me know good or bad thanks
  10. A

    mercury 1150

    I have a ? about the engine. The engine would turn over by hand so nothing frozen I spayed a little oil in the cyls and turned it over with starter first reading 1 90 2 130 3 130 4 130 5 130 6 130 So I sprayed some more oil and turned it over with starter I did this a few times new...
  11. A

    Center console deck repair

    New here Looking for some advice. I just purchased a fleetwing 21 foot center console with a soft center section of the deck. my first question is not about the deck but the actual whole boat the finish is all cracked up as shown in pictures. What I need to figure out before I get to involved is...
View older results
Top