Search results

  1. looking good

    looking good

    That's the shape
    • las
    • Media item
    • Comments: 0
    • Album: Transom from short to long
  2. reinforcement

    reinforcement

    Reinforced like there's no tomorrow
    • las
    • Media item
    • Comments: 0
    • Album: Transom from short to long
  3. top off

    top off

    Splashwell finished
    • las
    • Media item
    • Comments: 0
    • Album: Transom from short to long
  4. las

    Measurements of Chrysler flared washer/spacer and long cone

    According to the late Frank A it doesn't do much performance wise, maybe if there is a ventilation issue, but other than that not much. But the looks!! We lost so much knowledge with Frank, what a shame. I don't know if there ever was a one piece lower unit with 13 splines and thru hub exhaust...
  5. las

    Measurements of Chrysler flared washer/spacer and long cone

    Hi forum. It's a long shot but maybe some of you can help. And maybe this should be in the Chrysler section even though it's kind of a prop question... I just purchased a "new" SS 10x14 13 spline prop for my old 65HP Chrysler and need the flared spacer and the long cone. I have the short cone on...
  6. las

    Resurrection, Selco Select 13 ft

    In 2014 I bought a boat. Late 2014 I realized the boat and outboard should be scrapped before throwing more money at it! Late 2016 the boat hit's the water again, many hours and tons of cash later.... I just never seem to get smarter!!! When we first bought the boat with it's 35hp Johnson it...
  7. las

    Prop for 13 spline one piece lower, options?

    Now that my boat has finally been assembled and the engine started it's time to play with prop's. Last time out we hit 28/29 knots, 33/34 mph, at 5500 rpm and this makes me want to play a little with pitch, design and maybe even size! But this is not a "what pitch" question, but a "where do I...
  8. las

    Prop identification

    Hi, I'm having some issues, I think, with my prop slipping a lot at wot. I have a thread over at the prop forum regarding this but would like your input on my prop size. What do you make of these numbers? And maybe judging by the look of it!
  9. las

    Rectifier or voltage regulator

    Hi I have been searching for specifications regarding the rectifier on my 1978 65hp Chrysler and can't find out if the rectifier is a rectifier with built in voltage regulator or just a rectifier? My tach behaved rather funny when hooked up the last time I sailed the boat and I suspect the...
  10. las

    Ventilation 65hp chrysler

    Hi I have just finished part of the restoration on my 13 feet selco and got my 1978 65hp Chrysler running but are having some issues with the handling. Prop is a 10x17 aluminium i believe from the numbers stamped on it! It's hard to tell but I think it says 493 17 first test run with two...
  11. las

    Chrysler 65hp wiring

    Could someone point me in the right direction regarding finding a wiring diagram for the prestolite conversion done on my engine. I would like to hook up a tachometer and find the wiring for shutting the engine off. I just counted the coils under the flywheel and found 15! I thought these...
  12. las

    Just bought a 65hp Chrysler, a no runner

    Hi from Denmark I just bought an old Chrysler 65hp outboard and need some advice on parts and troubleshooting. The guy I bought it from said that he could only get it going on the lower cylinder and that the upper was dry. He opened up into the reed valves and said that they where not closing...
View older results
Top