Search results

  1. O

    Help. Hydro locked my 6.2mpi. 2001 sea ray 23’

    I need advice as to what’s next. Today after a 10 minutes cruise, then a 3minute idle speed cruise, the temp alarm went off showing 220 on the gauge so I killed the engine. I popped the hatch and my IR temp gun read 160-185 on various parts of top of engine. Oil filter temp was 185. Elbows/...
  2. O

    Bravo 1 to bravo3 interchangeably?

    I need to replace the bravo 1 on my new to me 2001searay select with a 6.2l due to extreme electrolysis. I’ve a line on a used bravo 3 for reasonable price and I need to know if this is a direct swap. thx in advance.
  3. O

    Prop size needed for replacement 50 hp johnson

    I’ve a ‘86 Johnson 50 that I knocked a sizable chunk out of aluminum prop. I need to replace. I can’t find a size stamped or marked on this aluminum prop. Anyone know the size so I can shop?
  4. O

    1986 Johnson 50 fuel problem under load

    J50tlcde. New to me Problem: will not run on both cylinders when under full acceleration after approx 10 seconds. If I keep squeezing the bulb making bulb rock hard it’ll run indefinitely under hard WFO. Let 10 seconds (or less) go by w/o squeezing and it’ll drop a cylinder. Squeeze to hard...
  5. O

    exhaust riser acceptable temp range?

    ive A new to me 2001 23’ sea Ray with a 6.2L , 320HP engine. When I hand test the temp of the risers, I can’t keep my palm on the top for more than a few seconds due to temp. This is much hotter than my ‘95 7.4L riser. Is this model riser supposed to be hotter or should I get right on with a...
  6. O

    Educate me: what is a looper engine and it’s differences

    go.....
  7. O

    Johnson 50 1986 tilt trim ISO

    im looking for an OEM tilt/trim assembly including motor, 2 cylinders and brackets. A 72- 89 year model for all 2,3 and 4 cylinders usually have the same part number. Make me an offer
  8. O

    Mystery water leak

    Boat: 1995 wellcraft eclipse 232 with carbed 7.4 Earlier this spring I took off the lower unit and replace the original U joints. Since bolting it up I have had more bilge water than normal. Yesterday while on a sandbar I look back and saw and heard Water entering the bilgeat a rate of a gallon...
  9. O

    Preventive maintenance for exhaust risers

    Gentlemen, its been a few years since I last visited this sight but I've a question for PM on exhaust risers. I've a 95 well craft with a 7.4L and bravo 1 with 500 hrs on engine and original risers used exclusively in fresh water with raw water cooling. What is suggested PM or replacement time...
View older results
Top