Search results

  1. junior1113

    disconnect vro to prevent engine damage?

    i have a 93 200hp evinrude ocean pro on a hydrasport. have no problems with any of it. keep hearing and reading it is a good thing to do away with vro and premix into tank. to prevent engine failure due to lean oil conditions. does the vro use more or less oil depending on rpm. any input...
  2. junior1113

    alarm came and went

    was out today and while i was racing my buddy in and while i was trimming up and got a constant alarm and engine start acting funny. shut engine off and started back up and all was fine. thinking i over trimmed or sucked sea weed in water intakes. could this cause this to happen. i believe...
  3. junior1113

    72' merc 9.8 fuel pump question

    if i pump ball all day it runs fine. if i stop it will soon stall and prime ball will be empty. went to rebuild and noticed it pumps gas by the compression of the motor. what to replace. thanks-paul
  4. junior1113

    93' 200 evinrude ocean pro?

    one problem after another with this setup. what i thought was a fuel restriction problem was'nt. replaced water seperator and anti syphin valve. tested today and sputtered on plane and only made it to 5000 rpms then went back and forth between 5800 ans 5000. second time took a while to plane and...
  5. junior1113

    gas leaking out of carbs when ball pumped (please look at pics)

    ok having trouble with pics 93' 200 ocean pro have had inti siphon go out. and further investigation when priming motor i noticed gas coming out of lower cowling so i removed carb cover and pumped ball and gas was coming out of all 6 carbs. doubting all the floats went at once. was thinking fuel...
  6. junior1113

    primer bulb went flat

    noticed rpms were at 4500 and had my buddie pump bulb and it went flat on him after a few minutes wot rpms went up to 5800 where it should be. thinking flat primer is related to low rpms and rough idle when cold started. what would cause primer to go flat was thinking new primer and new siphoner...
  7. junior1113

    bennet trim tab switchs make feul guage move?

    been doing a bunch of work on boat and of coarse now when i use tabs the gas guage goes to empty untill i let off tab switch. any ideas?
  8. junior1113

    peeing water but not hot

    93' 200 hp ocean pro. had boat out today and ran for an hour or so. when i got it home and was flushing i noticed water was peeing good but not hot like ussual. pulled two hoses off the t-stat. and t stat was pumping hot water out of the 2 outlets. did'nt over heat. wondering if this sounds like...
  9. junior1113

    fuel restriction alarm?

    just put a water separatoron my 93' 200 hp ocean pro. had no prior issues. and now fuel ristiction alarm sound when running over 4200 rpms. i have triple checked all connections and hoses. when i sqeeze primer ball i can see air bubbles going into my in line fuel filter. could this simply be...
  10. junior1113

    importance of water separater

    my boat does'nt have one. any input?
  11. junior1113

    what are symtoms of water in gas

    have no water separater and had a proplem ran like crap then ran good again
  12. junior1113

    93' 200hp oceanpro

    ran great all the way to the fishing hole (about 5 miles). fished for a couple hours and went to leave and motor just sounded like crap. went to get on plane and it was just rough didnt want to plane. hard to explain sound in writing, but i know it sounded diferent. it wasnt lopeing. let it sit...
  13. junior1113

    hwsiii can you do slip formula for a 4 blade

    i lost the form you e-mailed me 1993 hydra-sport 2000 cc 20" 1993 200hp evinrude ocean pro 1;1.86 14.25x17x4blade turbo ultima. 5800rpms @ 48 mph, 3500 rpms @ 25 mph . 4200lbs with persons motor and gear. have went through 4 props and this is the best one. thanx-paul
  14. junior1113

    very scary situation

    i was working on a lake house and there were many boats out, and all the sudden i heard a boat wide open loud like out of water. stopped what i was doing and saw a boat like 100 ft up on land ran up to it and there was no one to be found. i shut this like brand new searay jet boat off before it...
  15. junior1113

    how to decarb 200 oceanpro

    want to do a decarb and unsure of the process thanx
  16. junior1113

    john/rude the only way to go

    why do i always find myself towing the rest in. becuase they settled for something other than the best. last week i towed 2 mercs in lol. evinrude is like ford trucks the best never rest 93' 2000 cc hydra sport 200hp evinrude _________________________________ 05' f150 5.4 330ci 4x4 = more...
  17. junior1113

    how i realized it was a left hand lower unit

    heres a good one bought a used lower unit, instaled it and launched. as i went to back the boat up away from the dock the current was pushing me in so i (goosed) it in reverse, like normal and i flew foward right in to the dock this is when i realized i had bought a left hand lower unit. this...
  18. junior1113

    what color should lower unit oil be

    went out today and had a good time. pulled the boat out and noticed fishing line in and around prop and behind prop thrust washer. pulled a sample of lower lube and its like a greenish kinda brownish color not really cloudy but not clear. started out golden and clear (penziol) only have maybee...
  19. junior1113

    dhadley take a look

    ultima turbo 4 left hand prop -ran out great. best money ever spent. great hole shot. better mph all through throttle ranges. hits 5750 @45.6 gps so i gained 2 on top end too thanks again -paul
  20. junior1113

    what hp for kicker

    have a 93 21' hydra sport deep v 200 hp 4000lb setup and would be in 2-4 ft seas and would have for an emergency only i have a 68' merc 6 hp thinking to small for fighting waves. i also have a 72 9.8 merc w/ thunderbolt ignition runs good any knowledge on kickers appreciated they both push my...
Top