Search results

  1. K

    winterizing question

    Thank you for taking the time to reply. I appreciate the information
  2. K

    winterizing question

    Thank you very much for the info. I appreciate your time. I think I would like to leave the AF in the block just to keep the rust out.
  3. K

    winterizing question

    Hello, I have a MerCruiser 2011 4.3 MPI. I live in Northern WI. Question, After I get all the water out of the block do I leave antifreeze in the block over the winter or drain that as well ?
  4. K

    2011 Tahoe Mer 4.3 - engine miss firing

    Here is a question: -- So I bought my boat into a tracker dealer for the above issue I have been having. Has anyone heard about this issue that has caused my problems? The only thing they could find was a bad battery cable. Has anyone had that issue before and if so, did it fix the...
  5. K

    2011 Tahoe Mer 4.3 - engine miss firing

    What would cause the fuel pressure issue? Thank you for taking time to help me here.
  6. K

    2011 Tahoe Mer 4.3 - engine miss firing

    I have also noticed that it seems to happen when the fuel tank is around 1/2 tank. By measuring the fuel pressure what would that tell me. Sorry kind of new to this inboard motor. I've always had outboards
  7. K

    2011 Tahoe Mer 4.3 - engine miss firing

    Hello - It is injected. Fuel Filter is clear. Plugs look a little dirty.
  8. K

    2011 Tahoe Mer 4.3 - engine miss firing

    Hi, I have this 4.3. I been having an issue when this boat starts to run very rough, almost like it's starving for gas and backfires. I shut the engine down and after about 20 minutes it runs great again for a day or 2 and then it does this rough running and back firing. When you give it gas it...
  9. K

    Throttle cable end - 4.3 Alpha 1 MPI

    Thank you so much.
  10. K

    Throttle cable end - 4.3 Alpha 1 MPI

    Hello, I took off the cable. I measured and it's 12.5 feet. Can just order one from the link you sent me?
  11. K

    Throttle cable end - 4.3 Alpha 1 MPI

    Thank you so much for your help.
  12. K

    Throttle cable end - 4.3 Alpha 1 MPI

    Going to attempt to remove the cover tomorrow and then measure this puppy. Wish me luck.
  13. K

    Carb to MPI problem 2011 Merc 4.3

    Re-checked rotor and cap. Everything is good and burrrrr like a kitten.
  14. K

    Throttle cable end - 4.3 Alpha 1 MPI

    I have no idea how it broke. I went to start boat up and found this broke. The cable end looked twisted so maybe too much pressure made it break ?
  15. K

    Throttle cable end - 4.3 Alpha 1 MPI

    Do you if here is any videos out there on the change cable
  16. K

    Throttle cable end - 4.3 Alpha 1 MPI

    Looks like the hard part will be getting the cable off from the control mechanism. Off the motor is a piece of cake.
  17. K

    Throttle cable end - 4.3 Alpha 1 MPI

    Thank you for helping me.
  18. K

    Carb to MPI problem 2011 Merc 4.3

    Well Looking at the picture again. I better double check and make sure rotor is sitting correctly. Seems like cap shouldn’t have fit right.
  19. K

    Throttle cable end - 4.3 Alpha 1 MPI

    That would be amazing if you could help me with the materials. Thank you thank you
  20. K

    Carb to MPI problem 2011 Merc 4.3

    Everything seated down good. Cap went on with no issues
Top