Search results

  1. Greg O.

    QD12 shift rod O ring replacement.

    I am re-sealing the lower gear case on my QD12. How do I replace the o ring for the shift rod? Also any good suggetsions on removing the drive shaft seal, and the prop shaft seal? Should I use a sealer around the spaghetti seal, as well as the shaft seals? Another question, should I use a...
  2. Greg O.

    How do I upload an icon photo?

    I was trying to post an icon photo. I went into my profile and clicked on the area for the icon, but noting happens. What am I not doing right? Thanks.
  3. Greg O.

    Compression question

    I recently bought a beautiful 1957 10hp Johnson. It was late in October, so I didn't have much time to run it much before winter set in. I was checking the compression on another motor, so I decided to check this 10hp motor. I was shocked it was only 70psi on each cylinder. The motor...
  4. Greg O.

    1957 10 HP lower seals

    I recently purchased a beautiful 1957 . It does however leak oil out the upper seal of the gear case. I am not able to figure out the part number for the upper seal. The original parts book that came with the motor lists the upper seal as part number 41-62. Can someone cross that number to a...
  5. Greg O.

    1955 7.5hp Evinrude

    This summer I bought a 1955 7.5hp Evinrude. I have a few questions about it. It seems to have good compression, but when I checked it I was only getting 75 to 80 psi. The engine was room temp, about 65 degrees. I had it running back in August and it seemed to run pretty good, but the carb...
View older results
Top