Search results

  1. H

    1977 85 hp v4 evinrude power trim/tilt motor

    I bought a used boat this weekend, and have a couple of questions. The power trim motor has 3 wires, does the motor run in both directions? Also, I need a used motor. The one in the boat has a cracked cap.
  2. H

    1977 Evinrude V4 Evinrude Power Trim

    I just purchased this engine. I need a Power Trim motor for it. Does anyone know where I can get a used one? I'll probably need the harness that goes with it. The one that is in it is shot. Also, where can I get a wiring diagram for this engine?
  3. H

    looking at boat that sank-need advice

    I'm thinking about checking out an evinrude 175 that was under fresh water for 2 days. The engine hasn't been cleaned out or run since then. Any recommendations if this is a good idea. The boat is cheap, but im not sure how bad a project like this can get. What should I look for?If it was under...
  4. H

    Need 1965 33hp Evinrude SkiTwin Alternator

    I'm looking for an alternator/generator with mounting bracket that will fit this engine.
  5. H

    1965-1968 33hp Evinrude Ski Twin

    I'm looking for a 33 hp engine for parts. Please contact me if you know of one.
  6. H

    Looking for 65-70 33 hp Evinrude Parts Ski Twin

    I'm looking to buy parts for 65-70 33 hp Evinrude Ski Twin. I'll buy an complete engine that's not running.
  7. H

    1965 33 HP Evinrude Ski Twin

    I'm looking for parts for 1965 33 hp Evinrude Ski Twin. I need a shift shaft with the bracket that connects to the shift cable.
  8. H

    1965 33hp Evinrude High Speed Adjustment

    I just rebuilt this engine. The low speed adjustment works fine, but I can't get any<br />power out of the engine at the high end. I check the synchronization, that seems fine,<br />and the points are set to .020. The high speed needle valve has a rounded end, not needle<br />shaped. Is this...
  9. H

    1965 33HP Evinrude Shift Rod

    I just started fixing up a 1965 33HP Evinrude, and found that the shifting rod in the upper housing is bent. How do I replace it?
View older results
Top