Search results

  1. T

    need help with year ID

    Any one know the engine year J50BELCNR.<br />Thanks,Tom
  2. T

    What is a link and sync

    Can any one explain Thanks,Tom
  3. T

    70 hp no power

    Hi,<br />I have a 77 70 hp johnson that has no power At wot the motor turns about 2k. All carbs were dismatled and soaked in carb cleaner with new kits installed. Engine fires on all 3 cylinders and idles great. I also tried pumping the primer bulb while the motor was running with no effect on...
  4. T

    chrysler heads

    Hi,<br />Does any one know what year chrysler made the flat cylinder head.<br />Thanks,Tom
  5. T

    3 motors all same problem?

    I have a 18 foot center console that had a 1986 50 hp Johnson.Boat would get up and go with no problems. When the lower went bad I bought a 1977 50 hp Evinrude this motor did nothing but bog down and wouldn;t plane the boat. Then I bought a 1982 60 Hp Merc same problem. Now I have a 70 1977 Hp...
  6. T

    Chrysler over heating

    I have a 76 Chrysler 105 Hp that over heats.With the lower unit off and my garden hose hooked to the water intake tube there is a lot of bach pressure and I can;t get water up to the thermostat housing. I forced a snake up the tube but it only goes about a foot and a half to two feet and stops...
  7. T

    Need ignition wiring help

    Hi,<br />I changed over from a 1984 85 Hp Chrysler to a 1976 105 Hp chrysler. Is the ignition wiring different between these two motors. motor will crank but I have no spark.<br />Thanks for the help,Tom
  8. T

    Black wire on trim cylinder

    I have a 1977 70 hp Johnson and need to know what the black wire is for and where the other end goes.<br />Thanks,tom
  9. T

    Engine compression

    Hi,<br />I have a 1977 70 HP Johnson and would like to know what the compression should be. I took a compression test and all 3 cylinders show 105 pounds. Should this engine run good?<br />Thanks,Tom
  10. T

    50 hp force water in lower cylinder

    I have a 1990 50 hp Force. i pulled out the lower plug and found it fouled. It looked like a mixture of oil and water a milky white.Is this a blown head gasket or exaust gasket and are these parts easly replaced without pulling the powerhead? Thanks for the help,Tom
View older results
Top