Search results

  1. Isa4325

    Chrysler Magnapower 70 ignition woes

    Went for my first start after cleaning and checking the engine out for crank, compression, and plug wire voltages. My first crank with fuel/oil returned a pop and smoke bellowing out from below the flywheel as if from the Stator?????? Voltage to electronic ignition but nothing coming out to...
  2. Isa4325

    Removable or Tilt & Trim

    I want to remove my tilt & trim units completely from the Chrysler 70 Outboard and while reading in my repair manual it say to remove the lower shaft forst before removing the upper shaft holding the unit in place. HOW DO I REMOVE THE LOWER AND OR UPPER SHAFTS? DO I DRIVE THEM OUT FROM ONE SIDE...
  3. Isa4325

    1972 Ouachita Convincer U16 Hull Repairs/ Chrysler 70 207HE rebuilt engine.

    I want to re do the fiberglass work on the kell covering up some of the bare hull showing through. My thought is to use resin, hardener, and fiberglass cloth. painting it white to accent the hull. Any comments or suggestions would be helpful.
  4. Isa4325

    T&T Electrical Motor and Pump

    No Title I have pictures....
  5. Isa4325

    T&T Electrical Motor and Pump

    I currently have the combined assembly of my T&T pump and electrical motor off my boat and would like to test the motor for opertion. Can I just power up the motor from a jump off the bttery? If so I only have three wires coming out of the unit, one being a ground while the other two are colored...
  6. Isa4325

    Chrysler 70 Magnapower 70 HP Ignition Switch Problem

    I have a old INDAK 6 pin ignition switch I need to replace and do not know if the original switch is a 4 position switch. I'm looking at a Off, On, Start, Choke as the four positions. No INDAK part number, just (INDAK Pat Pend) the six pins are labled, B, C, S, M, I, M. Guessing, Battery, Choke...
  7. Isa4325

    Chrysler 70 707HE Outboard

    Reversing the engine doesn't stop kicking up. Saw this 180 switch that says "RELEASE" and "LOCK " When in release position this is what it looks like under the motor. When Locked it looks like this. My question is, what is the proper way to set the motor to lock when shifted into Reverse...
  8. Isa4325

    Chrysler 70 Magnapower 70 707HE

    I know this outboard is a two stroke using a 50 to1 oil/gas mixture but isn't there still oil in the engine lower case? No filter, no drain plug, I can't find anything that I would consider lower engine case oil or filter. Am I missing something here? Does this thing get lubricated from the...
  9. Isa4325

    Attaching Steering Cable to Outboard Motor

    How does a steering cable attach to a outboard motor without any holes for the center support and grease fittings???????? Sorry for the dim question buy I am in a quander.
View older results
Top