Search results

  1. S

    New engine installed!!!! but... (install pics)

    Hi folks, Engine is a 5.7GL 4BBL I will post up pics a little later of how the nightshift went installing the new lump. I have a couple of small issues but I am not sure that they are actually a problem... My old engine had a cylinder style coil and prestolite distributer... the new engine...
  2. S

    Outdrive Manual Request - SX-M

    Hi folks, Been looking through the available manuals and i'm unsure which manual applies to my outdrive. The id tag on the side has the following info - Product Number: 3868893 SX-M: 1:79 Serial: 4112071703 I intend to give the outdrive a thorough service, replacing bellows and u-joints...
  3. S

    New V8 Vortec, which oil for run in... I refuse to pay the money for the Volvo oil..

    The dealer oil is ?60 for 4 litres, I refuse to pay it! <can you blame me :-) Engine needs to be run in so I would appreciate recommendations on which oil to use. I'm in the motor trade and get all my engine oil at any spec at terrific prices, would some Mobil 1 Motorsport Fully Syn 15w50 do...
  4. S

    What stern drive to I have? Penta SX

    I have been looking for labels etc but can see little info.. It looks mucky but infact it's actually in good condition... I think there is marine antifouling on it which once cleaned off im sure it will clean up nice. I intend to inspect the gimble and UJ's as there is vibration through the...
  5. S

    Here's why I have a new engine coming :-(

    Can't wait to get it installed though... Video of the problem below > http://youtu.be/y53QzrBvMjg
  6. S

    Oil question 5.7 v8

    Volvo recommends Sae30 oil. Am I correct in saying a 5w30 or a 10w30 will have the the same +/- viscosity at running temp as the Volvo Sae30? My local volvo penta dealer was going to sell me 15w50 :-S
  7. S

    Can anyone recommend a fuel flow monitor / fuel manager that doesn't cost the earth?

    Its for a 5.7l 4bbl. Would like to find the perfect cruise vs consumption on my boat...
  8. S

    Fuel consumption question on 5.7 4bbl

    Hi folks, Not yet decided if my new 5.7 v8 is becoming a merc or a Volvo, I have access to parts for both. The engine will have a 4bbl with vacuum secondaries, 330hp im told. One thing is for sure, it will be a single prop outdrive on merc 23' highfive prop. I'm trying to establish on our...
  9. S

    New engine will arrive shortly, what is the swapping proceedure?

    I have ordered my new 5.7 V8 here > http://www.ebay.co.uk/itm/5-7L-350-5-7-New-V-8-Vortec-Marine-Extended-Base-Engine-/310338966535?pt=Boat_Parts_Accessories_Gear&hash=item4841a4d407 Can anyone point me to a proceedure for removal and replacement, I am not sure how much needs to be disconnected...
  10. S

    Custom made manifolds and risers???

    I tune performance engines and build custom stainless steel exhausts for a living but until now I had never considered doing anything regards my boat. I have a brand new engine going in shortly 2009 design 5.7 and I was considering making a jig and building custom manifolds/risers. It looks...
  11. S

    My engine is Junk, need to repower but what with?

    Finally after many attempts at trying to get my engine to run well the bigger problems became apparent. Oil pressure was a very real problem and now the engine is rattling like spanners in a washing machine. I have to decide what unit to replace as to be honest I felt the 5.7 may have been a...
  12. S

    5.7th cooling question

    Is it normal for the left manifold to be hot to touch and the right manifold to feel cool. I have just installed a thermostat into the housing where there was not one there previously. Any advice most welcome. Stan
  13. S

    5.7 V8 GL.... What does the fully assembled engine weigh?

    As per the title folks, I may need to remove it so just wondering if anyone knows :-)
  14. S

    5.7 GL Compression Test.... Also engine Alarm (Pics & Video

    I went to carry out a compression test tonight, grabbed hold of my spark plug socket wrench but it would not fit onto the plug as the manifold sits lower and makes it impossible.... is there a special tool to remove the plugs? My oil pressure alarm is sounding constantly when the engine warms...
  15. S

    Issue with Holley 2BBL idle tuning.

    Penta 5.7GL I have read many a report to turn the idle mixture screws in until the engine nearly stalls then back out half a turn but when I screw in the mixture needle on the right side there is no change, it seems to do nothing. The one on the left would stall the engine no problem. Am I...
  16. S

    Update on 5.7GL on Sundowner after forum support :-)

    Hi All, Was out on the water tonight after setting my timing and rebuilding my carb and for the first time the boat actually got on the plain.... Revs maxxed at 4000 rpm and geez it struggled to get out the water but it didn't backfire which was great. I must admit that I expected this boat...
  17. S

    Play in steering, Four Winns Sundowner 205

    I hope this is a simple fix, I have around an inch or so if play in my steering wheel before the outdrive responds, is there anyway to adjust this or do I need some new components? It's a Volvo 5.7 with sx drive. Best wishes Stan
  18. S

    Volvo 5.7 with prestolite distributer timing procedure.

    Can anyone help with this, I have searched all over but can only find info on the version that requires a jumper. Thanks in advance(pun intended) Stan
  19. S

    Which jets for Holley 2BBL on 5.7 I/0

    I have a Holley 2bbl on a 5.7 and need to know which jets are best suited. It is currently fitted with two jets with a number 65 on. The boat will be run at 7.9m above sea level in loch lomond so kinda irrelevant. All assistance really appreciated. Best wishes, Stan :-)
  20. S

    Volvo Penta 5.0/5.7 Running Issues - pics

    I just purchased a beatiful Four Winns 205 sports cruiser with what was advertised as a 5.0 gl but it now turns out it has had a 5.7 votec installed due to a previous engine failure. http://www.ebay.co.uk/itm/ws/eBayISAPI.dll?ViewItem&item=260811979604&ssPageName=ADME:B:WNA:GB:1123 It has a...
Top