Search results

  1. B

    Voltage drops to 12V when using tilt/trim

    My 1996 Merc 150 40 amp alternator normally keeps the voltmeter at 14v while running above 1K RPM. When I momentarily activate the tilt/trim switch even at 4K RPM the volt meter drops to near 12 volts. I can't find any reference to the tilt/trim motor current draw in my service manual, it is not...
  2. B

    Transdom trolling motor handeling question

    I have a 20 ft, deep V , Pro Line Walk Around Cutty cabin 3500 pounds rigged and fueled. I would like to set it up for some lake fishing over the winter here on lake Allatoona so I started looking into 70 lb thrust trolling motors. Unfortunately I would have to butcher (cut a section out) the...
  3. B

    What is correct winch and strap size ??

    I just purchased a 1996 Sea Pro 20 foot cutty cabin w/150 merc OB in terrific shape. However it came with a older LoadEaz trailer in need of some repair. While doing some hub bearing, and electrical work on the trailer I noticed the winch strap was frayed and the winch capacity stamped on the...
  4. B

    Installing Cleats w/o access to inside of hull

    I have a 1996 SeaPro 201 Walk around Cutty Cabin. When docking it only has three cleats two aft and one centered on the bow. Half the time I end up using the bow rail for short term tie-ups. I would like to add 2 more cleats, port and starboard midships, to ease docking. But because of the walk...
  5. B

    Looking for good boarding ladder for swim platform

    I just picked up this SeaPro model 201 outboard with a small swim platform on the port side of the outboard. Problem is the current single step ladder on the platform is way to short for senior citizens like myself to use when boarding from the water. Been browsing multiple sites for a...
View older results
Top