Search results

  1. J

    boat license fine

    does anyone know what the fine is for operating a boat without a license in new jersey. thanks jenny o
  2. J

    vibration in stern of boat

    i have a 1978 cris craft dory inboard that has a vibration when running a 2,800 to 3,000 rpms in stern of boat.prop has been reconditoned but i do notice that there is approx 1/8 inch play in prop shaft where it goes thrut strut bearing.could this be the cause of vibration or should shaft be...
  3. J

    oil leak concern

    i have a pleasure craft 302 ford marine inboard engine with a warner direct drive reverse gear that has engine oil running out of rear of engine mechanic says that rear main oil seal is leaking. parts are not available since the engine is a 1980 model. can i use a ford rear main seal used in...
  4. J

    question on boat company

    looking at a 1988 seaway downeast type cuddy cabin fishing boat built in maine with outboard motor mounted on stern bracket. does anyone have any opinions on this type boat good or bad. thanks jennyo
  5. J

    reverse gear question

    i have a 1980 schamrock cuddy with a 302 ford and borg warner 71c series transmission does anyone know what type of trans fluid is recommended for this trans. thanks jennyo
  6. J

    question on etec johnson motors

    does anyone know if the new johnson etec 115 2 stroke is as reliable as the old 88 hp spl motor. thanks for any information thanks jennyo
  7. J

    keelson problem leaks

    I Own A 1964 Cris Craft 24 Foot Runabout That Has A Leak Under Runner Post.it Appears That Wood Is Soft And Rotted Under Post.what Whould Be The Procedure To Repair This. Does The Whole Keelson Have To Be Replaced Since It Runs From Stem To Transom. I Do Not Want To Spend Too Much Money On A...
  8. J

    weight of old johnson 88hp

    i own a 1988 88 hp johnson spl motor that i am replaceing with a new etec115 johnson.i need to know approx weight of this motor i wanted to replace old motor with a same hp four stroke but just about everyone i spoke with says the extra weight may cause a problem.old engine is mounted on a...
View older results
Top