Search results

  1. K

    EZ Loader Sure Lube bearing system

    I have a EZ Loader trailer with the sure lube system. I replaced all the bearings two years ago and I have another bearing that is slightly rough. I replaced one of the axles when I bought the boat since the tortion axle was bent. The new axle does not have a vent hole for the grease like the...
  2. K

    Upper shift shaft seal replacement 1976 Mercruiser 888

    I am in the process of replacing the trim limit and trim indicator senders on my Dad's 1976 Slickcraft SS-235 and noticed corrosion in the bell housing area where the shift cable comes through. Upon further inspection, I noticed the sheath on the shift cable was split and corroded so we're...
  3. K

    Installing U-joint bellows to transom assembly - 1976 Mercruiser 888

    I have the exhaust bellows glued and clamped to the transom assembly and the U-joint bellows glued and clamped to the bell housing but I cannot get the bellows to seat properly on the transom assembly. Twice, I removed it before the adhesive set and cleaned everything with lacquer thinner...
  4. K

    Replacing Trim indication and position sensors on Alpha 1 Gen 2 drive

    My trim gage began acting flakey and then went to the full UP position. I figured it was the trim indicator sender on the drive and sure enough, one of the wires was rotted off. I took the sensor apart and attached a new wire to it to get the gage on the dash working but would like to replace...
View older results
Top