Search results

  1. B

    1994 johnson 115, no spark

    no spark to the plugs, where do I start, power pack? kill switch? what do you think? thanks
  2. B

    1994 Johnson 70 high speed miss

    my 70hp has a high speed miss, very slight but can feel it kick in and out at high speed has recently had new plugs, fresh carb rebuilds, and new fuel filter any ideas??
  3. B

    minn kota problem

    i have a minn kota maxxum 74 pound thrust, broke the skeg off, took it apart had the skeg re-welded , put the foot back to gether and the prop will spin one time and then you can just hear it hum what did i do wrong? the prop when you spin it by hand does not spin freely, take it back apart and...
  4. B

    95 70hp Carb Question

    i read on here yesterday about turning a carb upside down to check the float at reassembly and have forgotten what it said to do with the float once it is upside down and cant find the thread again??? I have the center carb spitting fuel out the throat with new needle and seat runs fine WOT...
  5. B

    1994 70hp not enough fuel?

    my 70 hp at idle is not running on all 3 cylinders, as soon as I give appx 1/4 throttle (more gas) she clears up and you can feel/hear all the cylinders firing then. what is causing me not to get the correct amount of fuel at idle?
  6. B

    1994 70hp carb question

    what is the correct setting on the slow speed needle screws? do i close them all the way in and back them out? if so how many turns back out? if not how do I do it? thanks
  7. B

    Johnson pt/t question

    I have a 70hp Johnson with the internal PT/T looking from the back of the engine on the right hand side of the PT/T assy, there looks what appears to be the fluid bladder, am I correct in saying this and is this the PT/T reservoir? there is a screw sticking out the side of this reservoir, is...
  8. B

    Johnson 225 v-6 lower unit problem

    I had my 225 hooked up to the water hose flushing it out and noticed water blowing out both sides from where the lower unit bolts up I assume there is not a gasket or a seal between the two so what would keep it from leaking? what do I need to look for? thanks
  9. B

    86 Johnson 140 wont tilt/trim down

    my 140 trims and tilts up perfectly but when I hit the down button the motor runs and the tilt cylinder will not pull the engine down until the trim cylinders ahve fully retracted then it will trim all the way down - weird huh?<br />no leaks and fluid is full
View older results
Top