Search results

  1. R

    Stringer 400 oil plugs washers

    Nylon washers are 100% adequate for gearcase drain / fill plugs.
  2. R

    2001 Yamaha 90 2 stroke top bearing noise

    Post #1 says you want to replace the bearing.-----Now you say it is a clicking noise and not a bearing ????
  3. R

    PL-88 load adapter

    I doubt that there is a computer ( ECM ) on this motor.
  4. R

    1979 80HP Mercury

    4 days driving for me to get there.----But be careful with adjusting things.----Adjusting the idle stop screw and trunnion on the cable is where I would focus.
  5. R

    1979 80HP Mercury

    There must be a shop in your area that will help out with these adjustments.----Do not adjust things that you are not sure of.----Your location?
  6. R

    LH or RH Propeller Drive Unit

    Correct---Standing 10 feet behind the boat.
  7. R

    LH or RH Propeller Drive Unit

    A right hand unit ( in forward ) would LOCK turning the prop CCW and it would ratchet turning CW.
  8. R

    2001 Yamaha 90 2 stroke top bearing noise

    Looks like a needle bearing to me.----And the crankshaft surface is part of the bearing.----Needles run on the crank.----Was that bearing carefully located on the dowel when you assembled this motor ?
  9. R

    1979 80HP Mercury

    Prop must be turned when going from neutral to reverse.
  10. R

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    The 1959 to 1963 model 10 HP use the same cylinder head.
  11. R

    aftermarket water pump repair kits

    There are still folks who think that starting a motor without water to the impeller is an OK thing to do.
  12. R

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    The helicoil can be installed without removing the cylinder head.----Most small engine shops ( if you still have one ) can do this simple job.
  13. R

    1979 80HP Mercury

    The clutch dog is spring loaded.---If you remove gearcase in NEUTRAL it likely will go to forward during the work.----That is why there has been so much confusion in the past.----And it will continue to be confusing.----You need to confirm that control and lower unit are in the SAME position on...
  14. R

    Best 2 stroke oil for Chrysler / Force outboards

    Run with a TCW-III oil.----If you run the motor hard then use 45:1 ratio
  15. R

    What kind of damage from an I/O in salt water for 2-3 years?

    Turn around.----Take big steps in rapid succession.-----So many better projects are available
  16. R

    The midsection on my '93 Merc 135HPV6 has cracked

    Pictures?--------Involved in collision ?----Hit and run perhaps ??
  17. R

    Johnson 4.5 not spitting water

    Water level in your test bucket needs to be 6" above the impeller.
  18. R

    1979 80HP Mercury kill Switch

    I think you are referring to the fast idle lever.-----Used for cold starts and warm up.----It is to be all the way down before using the big lever for shift / throttle control.
  19. R

    Play on propeller shaft

    Remove prop.-----Check end play on the propshaft and report actual value.----Some aftermarket props require a different thrust washer set-up.---
  20. R

    1972 Evinrude 9.5(Model 9222m)- no spark

    Picture #3 ----Looks like insulator piece on points is broken / missing.
Top