Search results

  1. Bondo

    Bravo shifter / throttle install on a gen 2???

    Ayuh,.... " dual lever boat controls ",....
  2. Bondo

    1989 Mercruiser 4.3 LX, Alpha 1 Gen 1 Overheating

    Ayuh,..... Raw water pump parts are not cleaned up, 'n painted,.... When they're showin' any wear, 'n blemished,.... They're tossed, 'n Replaced with new a raw water pump kit,..... ;)
  3. Bondo

    Bravo shifter / throttle install on a gen 2???

    Ayuh,..... Sure,... No problem,.... Just pick a controller you like,.....
  4. Bondo

    Water in oil

    Ayuh,...... No problem usin' cheaper oil,..... Considerin' where yer at now, I'm thinkin' rain water ran down into the carb, past the rings, into the oil,.... Gettin' most of the water/ sludge out, then Run it,.... Motor heat will steam off any that's left,....
  5. Bondo

    What is Normal RPMs running In Neutral and out of water with ears?

    Ayuh,.... As I said,..... All the time,.....
  6. Bondo

    Constant 'Two Beeps' from my Four Winns 4.3

    Ayuh,..... Bein' an electronic motor, you need a 'puter to know what it's tryin' to tell you,....
  7. Bondo

    Starboard riser running hot

    Ayuh,.... Welcome Aboard,..... Risers never run the same temps on both sides,..... Is the motor dead level,..?? tip slightly it to the starboard side,..... It sounds to me, that yer chasing a ghost,....
  8. Bondo

    What is Normal RPMs running In Neutral and out of water with ears?

    Ayuh,.... Mine idles 650/ 700 all the time,....
  9. Bondo

    Batwing manifolds

    Ayuh,...... Not soon enough,...... :rolleyes:
  10. Bondo

    Seeking your knowledge on SX-M maint.

    Ayuh,.... Welcome Aboard,.... The drive might weigh 100 lbs, probably abit less,.... Use the trailer jack, 'n/ or a block of wood to set the elevation, so you don't really need to actually lift it,....
  11. Bondo

    Changing Impeller on Volvo 5.0GL

    Ayuh,.... No problem,...... You'll get abit of water, but not enough to worry 'bout,..... The bilge pump works, Right,..??
  12. Bondo

    carburetor suspect problems

    No worries then,....
  13. Bondo

    carburetor suspect problems

    Ayuh,..... Normal operatin' temps are well above comfortable to the hand,....
  14. Bondo

    VP 4.3GS Carb Tuning Vacuum Port?

    Ayuh,..... Carb fuel pumps usually run 4 to 6 psi,.....
  15. Bondo

    Antiseize on sparkplug threads

    Naw,.... It's a liquid, 'n it don't take much,..... I run AC Delco marine spark plugs, which have alloy bodies, insteada steel,....
  16. Bondo

    Mercruiser Oil Pan Replacement and Protection

    Ayuh,..... Rustoleum industrial enamel,....
  17. Bondo

    Another question about 3.0 Mercruiser crankcase breather hose

    Ayuh,.... Welcome Aboard,..... No reason to overly complicate a very simple system,.....
  18. Bondo

    Merc Alpha 1 trim solenoids strange behavior.

    Ayuh,..... Test for power on the green wire at the pump/ solenoid with someone holding the down switch,....
  19. Bondo

    shift issue and running with some noise from lower unit gear

    Nope,.... It'll pile up on the tiller arm, inside the boat,..... The gimbal bearing fitting is 'bout 1/2 way down the starboard side,....
  20. Bondo

    1987 Larson 120 motor removal

    Ayuh,..... Welcome Aboard,..... 8 nuts, 'n the drive is off,.... Seein's the motor is supposed to be lifted straight up, then out,.... You stand a serious chance of bending the drive's shaft, if you don't pull it 1st,....
Top