Search results

  1. C

    new carb

    Had the same problems with car carbs.
  2. C

    gps

    Call both equipment companies to get it absolutely right the first time.
  3. C

    new carb

    Finally found that it is approved for marine use on the JEGS website.
  4. C

    1986 Mercury 35hp Throttle/Spark Advance issue

    Are any cable clamps missing on either end of the cables ? All 4 ends are normally CLAMPED in place to prevent your problem.
  5. C

    1986 Mercury 35hp Throttle/Spark Advance issue

    Is the carburetor throttle shaft sticky ? Linkage AND spring both removed ?
  6. C

    Pulling flywheel 1990 3hp

    Heat and time. can do it. I remember auto HV plug wire breaking inside while outside looked & felt great. Tough to pin point sometimes.
  7. C

    1982 Johnson 50 Sea Horse - Constant Beep While Accelerating

    Once cooling water gets above 145 to 160 F. Some minerals in the water start sticking to hotter metal parts. Basic chemistry. Why us geezers used 130F Boat thermostats. Some salt water Commercial Clammers just removed the the thermostat. And reset the choke to be manual control. Spark plugs...
  8. C

    new carb

    Read reports and none say it is US CG approved ? Why not ?
  9. C

    new carb

    Sounds like a street rod. Make sure it has a great automatic choke for cold areas.
  10. C

    2002 5,7 Mercruiser exhaust manifold keeps cracking - 5 times this summer

    IT takes a HUGE thermal shock to cause Cast Iron or Aluminum manifolds to crack. Last test !! Buy another manifold from a supplier you bought from and then cracked. Put it on the GOOD engine. Drive same way. Will tell us about what is at fault. Engine or manifolds.
  11. C

    To Drain Or Not To Drain

    Mine is put into dry storage after drain & oil changes every September 15. By a marina. My old body and Arthritic fingers are too pained.
  12. C

    To Drain Or Not To Drain

    A lot of motors will have new blocks this spring. Too lazy to do a simple draining.
  13. C

    Aluminum boat

    That hull has weak pinhole spots. Do NOT sand all the way down to eliminate the black HOLES !!!
  14. C

    Cannon Downrigger Optimum TS Jammed

    Fairy Godmother. Please repair my jammed up motors. No cost.
  15. C

    MFS25 fuel in oil

    You need a good mechanic. NOW
  16. C

    Aluminum boat

    I did the polishing of the rear bench seat . WARNING !!!!!!!!! The reflection is so intense that you can not look in that GENERAL DIRECTION !!!!! Can you enjoy driving a car, if there are loads of reflections, from cars ahead of you ?..... Same annoying glare in a polished metal surface...
  17. C

    2002 5,7 Mercruiser exhaust manifold keeps cracking - 5 times this summer

    Are you using different manufacturers ? Or the same brand everytime . I keep thinking a bad casting of every manifold. Different manufacturers means EXACTLY THAT. NOT the same manufacturer selling to lots of your local sellers.
  18. C

    Keel rollers?

    If people who have never been taught CORRECTLY how to set up all the DIFFERENT types of trailers want to do it themselves ????? You may be repairing he boat bottom and the trailer. During your learning curve. Your boat to do whatever you want to.
  19. C

    Question about 2 batteries, 2 chargers, and switches

    You can USUALLY NEVER put 1 charger in SERIES with another. Many are wired GROUND and MINUS at the same screw in the charger. If you have series batteries ? Like trolling motors ? Connecting the 2 chargers in series ? PUTS the higher charger ground and minus voltage RIGHT ONTO the lower...
  20. C

    Nobody fishing?

    Driving ANY vehicle on ice ? CRUNCH I forgot about the many springs pumping up warm water. Oh well. Funeral next spring. Feel bad for the family.
Top