Search results

  1. flyingscott

    Opinions on aftermarket johnson/evinrude parts

    Sierra, wsm are good brands. There is also EMP PRODUCTS. And SEI PRODUCTS.
  2. flyingscott

    Engine building tip regarding gel-seal?

    I think they started doing that on the Etecs. So yes It can be done.
  3. flyingscott

    A couple basic testing questions

    How hard is it to pull as fast as you can until the gauge stop. If you have a manual start motor that you can start by hand. You can pull it 5 times with the plugs out and get an accurate reading. 5 times should be plenty to go until the gauge stops. Let's not overthink the simplest test you can do.
  4. flyingscott

    A couple basic testing questions

    Pull 5 BRISK times and read the compression. 2 strks build compression with Rpm.
  5. flyingscott

    1993 Johnson, 200 hp help!

    That doesn't look right. Should have 2 wires not 3. 1 from ignition 1 to ground might want to figure out what that one is doing.
  6. flyingscott

    1980 skeeter sf150 - Johnson 140hp tilt/trim?

    Your release is working fine. Your problem is somewhere else
  7. flyingscott

    rectifier

    Where did you get it from?
  8. flyingscott

    Johnson 1993 70hp head removal

    The exhaust cover will show you nothing. The lost foam cast blocks are different than the earlier blocks.
  9. flyingscott

    Johnson 1993 70hp head removal

    More than likely a blown piston. Pretty common on those if the waterpump update has not been done. You cannot see the pistons through the exhaust on that motor.
  10. flyingscott

    1993 Johnson, 200 hp help!

    Put up a pic of that switch. It should only have 2 wires.
  11. flyingscott

    Need guidance on Prop pitch and Power, 78 Johnson 55hp 55EL78S

    Good luck with your motor
  12. flyingscott

    1993 Johnson, 200 hp help!

    The flywheel is bent it is junk now. That's what happens when you hit them with a sledge. You cannot have 120 volts with a 12 volt battery. Have you checked the lanyard switch? Ignition switch?
  13. flyingscott

    1972 Mercury 402 lower unit off but stuck in forward

    If you put the motor shifter in forward and the lower in forward really can't screw it up.
  14. flyingscott

    1999 75hp Fuel Prime Issue

    Sounds like the motor is lean. Does it have low speed screws?
  15. flyingscott

    1972 Mercury 402 lower unit off but stuck in forward

    Put the motor shifter in forward and reassemble
  16. flyingscott

    Need guidance on Prop pitch and Power, 78 Johnson 55hp 55EL78S

    Compression isn't great. But it sounds like it is running on 1 cylinder.
  17. flyingscott

    1993 Johnson, 200 hp help!

    Your flywheel is junk.
  18. flyingscott

    Motor has no power under load

    By the way if That is a rev limiter
  19. flyingscott

    Motor has no power under load

    Your motor do what you want
  20. flyingscott

    Motor has no power under load

    What motor do you have? A 2+2 will has a propensity to break piston skirts above 5500. And yes they did come with Rev limiters.
Top