Search results

  1. C

    Trouble reinstalling pre-alpha drive

    pull it off and start all over.You are not even close to getting it installed.Looks to me like you dont have the drive shaft getting lined up through the gimbal bearing based on how far you are from getting it on.Get a handful of grease and starting at the splines ,slather it on all the way down...
  2. C

    Mercruiser Alpha 1 Gen 1 -- Gimbal bearing

    I recommend a standard gimbal bearing.I have never had one fail in over 30 years of stern drives.Grease in the spring,again in the fall upon seasonal hauling and again before launch.Zerks are good.They make/allow you depend on YOU.Not a bad thing.Charlie
  3. C

    Bought a new boat..loooads of questions LOL

    Good luck with the new boat.sounds like you need a buddy with similar to hang out with and show you the ropes a bit.One VERY BIG difference is going to be the handling while docking or in close quarters.Especially if you leave the plastic window up and there is any kind of breeze.If all attached...
  4. C

    Standard size drain hose for sinks

    I am wanting to replace my sink drain thru hull with a stainless thru hull.Does anyone know the standard size? Both my bathroom and kitchen look to be about an inch.Charlie
  5. C

    Can you start these in cold temperatures out of water?

    Yes correct.The kit includes the impeller ,impeller housing and wear plate with gaskets.As you already mentioned ,I would focus on getting it running first.Pull the plugs ,clean them up ,spray some starting fluid in each cylinder before putting each plug back ,fresh fuel and crank it over and...
  6. C

    Can you start these in cold temperatures out of water?

    Hopefully the engine WAS winterized prior to your getting it
  7. C

    Can you start these in cold temperatures out of water?

    it would help to know what engine and drive you have but I would 100% recommend a water pump service in any drive that is new to you
  8. C

    Dry joint exhaust pros/cons

    Thanks ,that is reassuring info.
  9. C

    Can you start these in cold temperatures out of water?

    You certainly can however you will have to run antifreeze thru it when you are done after you introduce fresh water into the system.If you pull the drive off ,you can try to start it without introducing water into the system as long as you are just trying to see if it runs.You can have it run...
  10. C

    Dry joint exhaust pros/cons

    Need to replace one of my 1988 5.0XL alpha motors.Found a complete drop in 5.0 bravo with dry joint exhaust approx 15 years newer at a very reputable boat yard.They said they are gonna pull the old motor and modify this one to accept an alpha to match what I have.I am a little leary of this...
  11. C

    No visible mold but there is a musky smell

    Ozone generator will help,HOWEVER it will burn out in a hot cabin.Been there,done that. IMHO ,I think you are missing something.It sounds like you have done a pretty thorough job with bleach but you are missing somewhere.I suggest flushing full strength REGULAR bleach down the head.Wait about a...
  12. C

    Hull vents

    The vents are multi-purpose.They allow fumes and vapor and heat and moisture to escape and the reverse vent pulls fresh air in as you are under way.I would not recommend eliminating any vents.Perhaps you can relocate a vent or extend the size of it,etc.Charlie
  13. C

    Airless paint sprayer,use old or buy new?

    I have a 30 year old craftsman airless that I have not used in a very long time.I plan on doing some exterior and interior house painting.Should I automatically assume that airless sprayers have improved greatly over the past 30 years and break out another $100 and get a new one?? Anyone used...
  14. C

    1988 Merc 5.0XL with alpha drives engine replacement suggestions

    thanks Matt,guess its worth a try fixing first
  15. C

    Alpha 1 clattering noise behind prop???

    It got better all by itself???? U joints....or if the clattering returns you can just turn up the stereo.Charlie
  16. C

    Waterline for 1964 16' Starcraft

    Best to launch the boat and let it sit in a slip or dockside with no one aboard for an hour or so.See if you can get it back onto the trailer without boarding it.There should be a waterline you can follow.Blue tape it off and then go several inches above that.Perfect would be to have the...
  17. C

    Starting Mercruiser 350HP In/Out Board Engine after 4 years

    MMO is Marvel mystery oil.Great for winterizing and long term lube.Its a good alternative to fogging oil.Fogging oil is the internal lube that is necessary for any storage that will be more than a month,Hopefully you pulled the tstat while last winterizing.Charlie
  18. C

    1988 Merc 5.0XL with alpha drives engine replacement suggestions

    That must have been a pretty good feeling when you got it all done.Yes I am on LI .Bummer as I used to have a few GM old time mechanics as friends that have since moved south.These guys could take apart a motor while holding a full blown conversation and put it back together so effortlessly.I...
  19. C

    Considering New Boat

    Regal is a great boat and it is not at a premium price point.I have owned 2 and I highly recommend them and the hulls cant be beat.I think they now have a lifetime warranty on the hull. Charlie
  20. C

    1988 Merc 5.0XL with alpha drives engine replacement suggestions

    Thanks again guys.I think I am gonna go over the options with a local reliable marine mechanic.Unfortunately my capabilities and experience are non existant when it comes to tearing down a motor.I am more of an exhaust manifold/riser,outdrive waterpump service type of guy.Just the basics sorry...
Top