Search results

  1. J

    Ford 302 pinging

    In theory should I be able to just turn the key with out pumping...beings it's old school technology..or a few pumps firat
  2. J

    Ford 302 pinging

    I've been meaning to ask this. My boat is hard to start cold. I have to pump throttle first 4 or 5 times and it usually takes a few rounds of that until it stays running on its own. Unless I lean into it a bit with the throttle. Seems odd to me
  3. J

    Ford 302 pinging

    Well that's commitment to both the car and the booze lol
  4. J

    Ford 302 pinging

    Yeah yeah little gto
  5. J

    Ford 302 pinging

    I'll trade my boat for your car lol
  6. J

    Ford 302 pinging

    I haven't went for a burn yet its snowing lol. I am going to run it a few times and perhaps I'm going to far with new parts. I just like to be prepared
  7. J

    Ford 302 pinging

    Would the 500 cfm on eBay be to many cfm or no. Also does it matter that it says omc
  8. J

    Ford 302 pinging

    The carbs I see are 800 - 1000 American...I'm canadian lol
  9. J

    Ford 302 pinging

    The fuel contamination is fixed and installed the anti siphon. Changed filters. Gas is good and clean. I do have closed cooling. To go from 2 barrel to 4 is about 2000 from what I can tell.
  10. J

    Ford 302 pinging

    Correct?
  11. J

    Ford 302 pinging

    I agree...I don't want to.mess around anymore. . Now when I go to buy carb I just say ford 302 2 barrel. Does anyone have an actual part number for me
  12. J

    Ford 302 pinging

    Also shows a holley 2 barrel
  13. J

    Ford 302 pinging

    This is a reply from mikes carburetor wich from what I understand this carb doesn't belong. Any input on what he says
  14. J

    Winterizing 4.3

    My old boat had brass bolts I could take out under manifold and also the pet cockon the block.
  15. J

    Winterizing 4.3

    I have drained the raw water side and blew air through just by mouth. There is only 2 fittings on my manifolds and they drain antifreeze. My block drains down low same. I ran winterproof through the hoses and watched it come out while I did elbow side. Then I poured it through hx side until it...
  16. J

    Ford 302 pinging

    Very true. It almost seems like it was to long to have the screen all smushed
  17. J

    Ford 302 pinging

    I pulled the brass 90...it had a screen on the bottom that to me looked squished on the end to the tube. There is an anti siphon valve there as well. However I dinged the 90 and now need to retread it.
  18. J

    Ford 302 pinging

    No I haven't how ever I will today
  19. J

    Ford 302 pinging

    I grabbed an anti siphon valve. Now shoukd I install it in my out feed to fuel pump from water separator or into fuel pump on out side to carb
  20. J

    Ford 302 pinging

    When I bought both the carb and mechanical pump I was told yes marine. The pump is a double diaphragm unit buy has no hose to carb. I believe I have asked these questions at some point on here and what I've got was right. My pvc however goes to vac port at base of carb not like yours
Top