Search results

  1. alldodge

    1988 mercruiser 260 9 pin engine harness to 10 pin harness

    Yes, should be able to swap anything and everything
  2. alldodge

    Trolling Motor Help

    ok it's an on/off toggle switch look for a DPDT 50 amp switch, and could get away with a SPST 50 amp switch. The SP switch would just disconnect the hot
  3. alldodge

    1988 Rogue 2420

    Thoughts still with his and your family
  4. alldodge

    1988 mercruiser 260 9 pin engine harness to 10 pin harness

    Look real close at the back of the harness and count the wires, are there 10 or really just 9 Most cases pin 9 is not used and why it's just blocked off
  5. alldodge

    '95-ish Glastron SSV195 carbureted mercruiser 4.3 starter solonoid wiring color codes

    Looks like you have it, don't use the old gas
  6. alldodge

    '95-ish Glastron SSV195 carbureted mercruiser 4.3 starter solonoid wiring color codes

    Sounds like you need a 3 position key switch. The 4 position switch is used if there are accessories need to stay ON when motor is off Purple-ignition yel/red-start The oil pressure switch is bypassed and needs to be put back correctly. The pur/yel connects to outside post and yel/red connects...
  7. alldodge

    Trolling Motor Help

    The manual is showing a 3 pin single pole double throw with one side being momentary Momentray/Off/On
  8. alldodge

    Trolling Motor Help

    Need switch terms single pole double throw double pole double throw
  9. alldodge

    Marine or Auto oil pan

    same as auto
  10. alldodge

    Trolling Motor Help

    Welcome I'm finding the 24v Minn Kota Edge 70 requires a 50 amp breaker/fuse, so you will need at least 50 amp switch. Here is a Switch which I found searching for 24V 50 amp switch Can also use a Battery switch Just search what I did and all kinds of types will show up, doesn't need to be a...
  11. alldodge

    Volvo Penta 3.0 Beeping and Ggoing Into Limp Mode

    I'm out of ideas, need a manual to go further The manual will indicate if you have problem X do Y test and that's were we are at
  12. alldodge

    No fuel in carb despite several attempts to crank

    Wild a$$ guess
  13. alldodge

    Water Heaters.

    It's a hot water heater
  14. alldodge

    Water Heaters.

    Moved it to electrical to get more eyes on the question
  15. alldodge

    Water Heaters.

    Good thing with boats is the low flow rate, so finding one that can produce the right GPM rate should be easier to find
  16. alldodge

    No fuel in carb despite several attempts to crank

    Agree with your statement, my comment was along the possibility if the module is not providing a good signal back to the module then it just "might" be causing issues I don't know, just a WAG and not meant to cause a change just a comment
  17. alldodge

    Water Heaters.

    It will work, the issue is sizing. Will need most likely need 30 amp breaker for even the smallest unit
  18. alldodge

    No fuel in carb despite several attempts to crank

    Yes the module controls advance and are NLA as new. Sometimes they can be found but issue is if they work Both TB4 and 5 had issues with pickup module in distributor with grounding. This is way Merc changed from 2 wire to 3 wire module which added a new ground wire. Not saying this may be...
  19. alldodge

    Alpha One steering pin and arm

    Here is a stainless steel
  20. alldodge

    Single point drain

    It varies but with the block full it will take less. The big thing is don't let the feed run out so not to damage the impeller
Top